Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Hateen
Sanitary fixture installation in Hateen means setting a tap, toilet, or bidet in the right place with water supply and waste outlet connected properly. Hateen is a mixed residential area in Hawalli with apartments and villas, and each fixture needs secure fixing, correct water pipes, and waste lines at the proper height.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Hateen houses are a mix of residential flats and older and newer villas, with many flats built on concrete slabs with waste stacks inside the walls. When we install a new tap, bidet, or toilet, we first note where the water chamber is and what pipe size runs to it, and where the nearest waste outlet sits. In older flats the pipes are thinner, so we choose fixtures that match the water pressure and flow rate.
Hateen sits in Hawalli governorate, a residential area with flats and villas on water and waste pipes of varied ages and sizes.
Many Hateen flats have vertical waste stacks in the walls instead of floor chambers, so we need to know their location before installing any bidet or toilet.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Hateen
Hot water needs slightly thicker pipes and thermal insulation because it expands, but cold water doesn't have that issue. We need to locate the hot water source in the house before we connect the tap.
We work with the space you have. We measure the lines and tell you if a smaller bidet will fit or if we can rearrange the fixtures differently to save room.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Hateen
Other work we do in the same area.
Back to Sanitary fixture installation