Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Jabriya
Sanitary fixture installation in Jabriya starts by understanding whether we are fitting in a villa or a flat, because Jabriya is a mixed district. The villas are relatively old and newer apartment blocks sit scattered among them, with drain lines running differently in each type.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Villas in Jabriya near Jabriya Co-op and Mubarak Hospital date from the nineteen-seventies and eighties, with waste pipes either buried under the floor slab or running through the ceiling depending on the house. Modern apartment blocks in Jabriya have pressure tanks and central pumps with high water pressure. When we fit a washbasin or bidet in an older villa, we drill carefully into the floor or wall to avoid cutting existing pipes. A newer flat needs strong fixings into thick concrete walls.
Jabriya sits in Hawalli governorate, a mixed district of older villas and newer apartment blocks.
Waste pipes in older Jabriya villas are narrower than in newer villas, because building codes were less strict decades ago.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Jabriya
Yes, there is a big difference. Older villas have narrow pipes and sometimes corroded metal, while newer ones have better design and plastic lines. We need more time in an older villa to make sure the new outlet is positioned correctly.
High pressure does not change our fitting method, but we verify the tap and valves are rated for it. We use heavy-duty metal washers and recommend a pressure relief valve if the pressure is excessive.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Jabriya
Other work we do in the same area.
Back to Sanitary fixture installation