Plumbing and sanitary
Ramadan Drain CleaningValve repair in Hateen
Valve repair in Hateen often starts when the water shuts off to an entire flat or house because the main valve is nowhere but the hallway. Hateen is an older residential area of mixed flats and villas, and the valves have aged with the pipes behind them.
Valve symptoms
When a valveneeds work.
A valve is a part that sits still, which is why you discover its fault at the worst moment.
01
Closed, and water still comes
You turn the handle until it stops and it feels shut, but the tap still gives a thin flow. That means the closing part inside no longer meets its seat fully, because of deposits or wear.
02
Seized and will not turn
A valve nobody has turned for a long stretch sticks as deposits build around the spindle. Forcing it snaps the handle or opens the spindle up, and you end up with a leak where there was none.
03
A weep at the handle
A drop appearing around the spindle when you open or close it. The packing that seals the spindle has tired, and that is often repaired without changing the whole valve if the body is sound.
04
The fixture has no valve
A basin, a toilet or a washing machine with no valve of its own means any small repair stops water to the whole house. Fitting an angle valve to each fixture changes every future repair.
This area
What setsthis area apart
Most houses and flats in Hateen were built decades ago, and the original valves now leak or will not shut properly. If the main valve will not work, we fit a new one in the same box before we touch anything inside the flat or house. In that box you might have a second valve for one section, but if it fails, everything stops. The tightly stacked flats near the old marketplace strip mean you cannot always open a valve box without asking a neighbour for an inch of space.
Hateen is an older residential area in Hawalli governorate, home to flats and small villas where many of the original valves date back to the first build.
The original Hateen valves are mostly old brass or cast iron, and corrosion clogs the ball inside.
In short
The valve work.
Service
Water valve repair, replacement and fitting
Types
Main valves, branch valves, angle valves at fixtures
Where they sit
At the tank, on the roof, in the yard, under fixtures
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From above itto below it.
Changing a valve needs another valve above it, and that is the first thing we confirm.
We find the upstream shut off
We look for a valve able to stop the water before the failed one, and if there is none we shut off at the tank outlet or the supply point itself.
We drain before opening
The lowest tap on the run is opened so whatever is left in the pipework drains out, because unscrewing a valve on a full line soaks the area and makes the work harder.
We repair or replace
If the weep is only at the spindle and the body is sound, the packing is renewed. If the closing part is worn or the body is tired, a new valve goes in its place.
We open and close it twice
Pressure comes back and the valve is opened and closed several times with a tap watched after it, because a valve that works once does not necessarily close properly the next time.
Common questions
Questions about Valve repair in Hateen
Yes, we can reach every external valve box from the flat or the common passage. But we can only fit a new one with permission from the building owner or the landlord.
We fit a new valve at the same point, and then you can turn off the water for repairs without shutting out the neighbours. The new valve lets you isolate just your flat.
Other services
Other services in Hateen
Other work we do in the same area.