Plumbing and sanitary
Ramadan Drain CleaningWater pump install and repair in Hateen
Water pump install and repair in Hateen begins with the fact that every house here depends on a roof tank and a pump to push water to every bathroom and kitchen sink. Hateen is a residential area in Hawalli, and its houses are older than newer districts, so most pumps here are worn down by years of use.
Pump symptoms
When the pumpis the cause.
A pump complains before it stops, and its symptoms are distinctive.
01
It cycles on and off fast
The pump starts, stops, and starts again while a single tap is open. That means the pressure vessel has lost the air cushion inside it, so the pump has no margin to rest between starts.
02
The noise changed suddenly
A different hum, a rattle, or a new whine. Fresh noise is usually air pulled into the suction side or a tired bearing, and both get worse if the pump is left running as it is.
03
It runs but nothing comes
The motor turns normally but the taps give nothing. The pump has lost its prime, or the tank is empty, or the suction valve is closed. Leaving it spinning dry burns the seal inside it.
04
It heats up and cuts out
The pump stops after a spell of running, then restarts once it cools. That is a thermal cut out doing its job, caused either by constant running from a leak on the line, or by a pump smaller than the house needs.
This area
What setsthis area apart
Houses in Hateen are mostly older villas and small apartment blocks, and the pump usually sits in the maid's room or ground floor under the main water inlet. The lift pipes are fairly long because the distance from ground to roof is high, and every year salt and water eat away at the motor. If the pump wears out, water won't flow from the shower with proper pressure, or may not reach the upper floors at all. We check the electrical connections, the check valve, and look for leaks in the horizontal lines.
Hateen is a residential area in Hawalli governorate, containing older villas and small apartment blocks, mostly home to families and office workers.
Most pumps in Hateen run at three-quarters capacity because of mineral salts in the water.
In short
The pump work.
Service
Water pump installation and repair
Types
Surface booster pumps, and submersible pumps inside a ground tank
The work includes
Pressure vessel, pressure switch, non return valve, float
Where it applies
Houses, flats, blocks, complexes and chalets
Electrical side
The electrical connection is an electrician's work, not ours
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From suctionto delivery.
A pump is read from both sides: what goes into it and what leaves it.
We check the tank first
The water level, the float and the outlet valve. A healthy pump on an empty tank gives exactly the same symptoms as a failed one.
We check the suction side
Any air drawn in through a joint on the suction side stops a pump pulling, even if not one drop of water leaks out of it. Joints are tightened and the non return valve is checked.
We check the vessel
The vessel holds air behind a rubber diaphragm, and that air is what stops the constant cycling. We check it, recharge it, and replace it if the diaphragm has split.
We run it and test at a tap
The pump runs and we open the furthest and highest tap in the house, because the result is measured there and not at the pump itself.
Common questions
Questions about Water pump install and repair in Hateen
Water comes out weak from taps and shower, or you hear strange squealing from the pump location, or water does not reach upper floors at all. Any of these means you should call us before it stops completely.
You don't have to replace the pipes unless they leak or show clear corrosion. But if the pipes are old and rusty, it is better to change them so the new pump lasts longer.
Nearby areas
More areas for Water pump install and repair
Same service, in nearby areas.
Other services
Other services in Hateen
Other work we do in the same area.
Back to Water pump install and repair