Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Hawalli Midan
Sanitary fixture installation in Hawalli Midan means setting toilets and taps in shops, clinics, and residential flats above in an old commercial district. Hawalli Midan in Hawalli is near the popular market, with flats above shops and uneven floor levels and non-standard piping.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Hawalli Midan is an old commercial district with ground-floor shops and residential flats above, and floor levels differ between shop and flat. Pipes run down from the roof through aged walls that may be cracked or tilted. When we install a tap or toilet in a shop or clinic, we inspect the wall and measure existing pipes. Residential flats above shops are sometimes old and cramped, so we work carefully to avoid damaging residents' walls.
Hawalli Midan sits in Hawalli governorate, an old commercial district with shops and residential flats on non-standard piping and aged walls.
Shop and residential floor levels in Hawalli Midan differ in height, so we must calculate pipe slopes precisely to ensure drainage works correctly.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Hawalli Midan
Old walls may be weak and pipes may be corroded or too narrow. We inspect first and tell you if we need new pipes or a different mounting method.
Yes, but we must check the flat's lines and try to connect it from another direction without using the shop's shared pipes.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Hawalli Midan
Other work we do in the same area.
Back to Sanitary fixture installation