Plumbing and sanitary
Ramadan Drain CleaningWater pump install and repair in Yarmouk
Water pump install and repair in Yarmouk starts with checking the tank, pressure and electrical wiring. Yarmouk is an older residential area in Kuwait governorate, with ageing apartment blocks and roof tanks, and most of the pumps in them have run for years.
Pump symptoms
When the pumpis the cause.
A pump complains before it stops, and its symptoms are distinctive.
01
It cycles on and off fast
The pump starts, stops, and starts again while a single tap is open. That means the pressure vessel has lost the air cushion inside it, so the pump has no margin to rest between starts.
02
The noise changed suddenly
A different hum, a rattle, or a new whine. Fresh noise is usually air pulled into the suction side or a tired bearing, and both get worse if the pump is left running as it is.
03
It runs but nothing comes
The motor turns normally but the taps give nothing. The pump has lost its prime, or the tank is empty, or the suction valve is closed. Leaving it spinning dry burns the seal inside it.
04
It heats up and cuts out
The pump stops after a spell of running, then restarts once it cools. That is a thermal cut out doing its job, caused either by constant running from a leak on the line, or by a pump smaller than the house needs.
This area
What setsthis area apart
Most Yarmouk flats are older residential blocks from the sixties and seventies, with the roof tank above and drop lines feeding the units below. The pump runs on electricity and pushes water from the tank to the taps, and its wiring can be old. When we arrive we inspect the motor, the float switch and the line from the tank, and we check the flat's pressure with a small gauge.
Yarmouk sits in Kuwait governorate, an older residential area dominated by multi-storey apartment blocks.
Most Yarmouk tanks sit at roof level, and the pump runs continuously to maintain pressure in the upper flats.
In short
The pump work.
Service
Water pump installation and repair
Types
Surface booster pumps, and submersible pumps inside a ground tank
The work includes
Pressure vessel, pressure switch, non return valve, float
Where it applies
Houses, flats, blocks, complexes and chalets
Electrical side
The electrical connection is an electrician's work, not ours
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From suctionto delivery.
A pump is read from both sides: what goes into it and what leaves it.
We check the tank first
The water level, the float and the outlet valve. A healthy pump on an empty tank gives exactly the same symptoms as a failed one.
We check the suction side
Any air drawn in through a joint on the suction side stops a pump pulling, even if not one drop of water leaks out of it. Joints are tightened and the non return valve is checked.
We check the vessel
The vessel holds air behind a rubber diaphragm, and that air is what stops the constant cycling. We check it, recharge it, and replace it if the diaphragm has split.
We run it and test at a tap
The pump runs and we open the furthest and highest tap in the house, because the result is measured there and not at the pump itself.
Common questions
Questions about Water pump install and repair in Yarmouk
The tank might be low or the pump may have weakened. We check the whole line and run a small gauge to see what pressure reaches upstairs. Sometimes the tank's float switch isn't working right and needs repair.
Yes, we kill power to the old pump and disconnect it from both the pipes and the wiring. Then we fit the new one in the same spot and test it before restoring power.
Nearby areas
More areas for Water pump install and repair
Same service, in nearby areas.
Other services
Other services in Yarmouk
Other work we do in the same area.
Back to Water pump install and repair