Plumbing and sanitary
Ramadan Drain CleaningWater pump install and repair in Bnaid Al-Qar
Water pump install and repair in Bnaid Al-Qar deals with beachfront houses and old pipes in the nearby industrial zone. Bnaid Al-Qar is a waterfront district in Kuwait governorate, most of its housing is modern blocks with tall water towers or large rooftop tanks.
Pump symptoms
When the pumpis the cause.
A pump complains before it stops, and its symptoms are distinctive.
01
It cycles on and off fast
The pump starts, stops, and starts again while a single tap is open. That means the pressure vessel has lost the air cushion inside it, so the pump has no margin to rest between starts.
02
The noise changed suddenly
A different hum, a rattle, or a new whine. Fresh noise is usually air pulled into the suction side or a tired bearing, and both get worse if the pump is left running as it is.
03
It runs but nothing comes
The motor turns normally but the taps give nothing. The pump has lost its prime, or the tank is empty, or the suction valve is closed. Leaving it spinning dry burns the seal inside it.
04
It heats up and cuts out
The pump stops after a spell of running, then restarts once it cools. That is a thermal cut out doing its job, caused either by constant running from a leak on the line, or by a pump smaller than the house needs.
This area
What setsthis area apart
Bnaid Al-Qar has relatively modern blocks with tall steel water towers, and some older houses near the old road. The tall towers need high-power pumps because the lift distance is long. Sea water and salty air accelerate rust on pipes and fittings, so we watch for corrosion and swap parts before they fail. The pressure switch and motor must be rated for high pressure and continuous use.
Bnaid Al-Qar is a beachfront area in Kuwait governorate near the old airport road and bordered by industrial zones.
Water towers in Bnaid Al-Qar are very tall and the vertical distance from ground tank to roof often runs thirty metres or more.
In short
The pump work.
Service
Water pump installation and repair
Types
Surface booster pumps, and submersible pumps inside a ground tank
The work includes
Pressure vessel, pressure switch, non return valve, float
Where it applies
Houses, flats, blocks, complexes and chalets
Electrical side
The electrical connection is an electrician's work, not ours
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From suctionto delivery.
A pump is read from both sides: what goes into it and what leaves it.
We check the tank first
The water level, the float and the outlet valve. A healthy pump on an empty tank gives exactly the same symptoms as a failed one.
We check the suction side
Any air drawn in through a joint on the suction side stops a pump pulling, even if not one drop of water leaks out of it. Joints are tightened and the non return valve is checked.
We check the vessel
The vessel holds air behind a rubber diaphragm, and that air is what stops the constant cycling. We check it, recharge it, and replace it if the diaphragm has split.
We run it and test at a tap
The pump runs and we open the furthest and highest tap in the house, because the result is measured there and not at the pump itself.
Common questions
Questions about Water pump install and repair in Bnaid Al-Qar
Yes, a stronger pump runs at higher voltage and draws more current. But if the pressure switch is clean and there are no leaks, the pump stops and rests once pressure is reached, so overall use balances out.
A submersible pump sits inside the tank in the water, and a centrifugal pump stands outside the tank and pulls water through a pipe. Most Bnaid Al-Qar tanks use centrifugal pumps because the tanks are rooftop and the water runs down outside.
Other services
Other services in Bnaid Al-Qar
Other work we do in the same area.
Back to Water pump install and repair