Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Yarmouk
Sanitary fixture installation in Yarmouk means fitting a wash basin, toilet, or shower so the water supply and waste line connect right from the start. Yarmouk is a mixed residential area of flats and villas, and sanitary fixtures vary widely from unit to unit.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Yarmouk flats typically have a main bathroom and an ensuite, while villas have more. When we install a new basin or toilet in a flat, we first locate the nearest waste outlet in the floor or wall, and measure the water height from the ceiling or tank. Villas near the co-op area have more space for pipe runs and concrete slab floors, making installation cleaner without cutting extra walls.
Yarmouk is in Kuwait governorate, a mixed residential area of flats and villas near Yarmouk Co-op and Yarmouk Sports Club.
Newer Yarmouk flats usually have an elevated roof tank, while older units have direct water feed from the street line.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Yarmouk
Yes, if there is enough space under the slab for the pipes and waste is nearby. We check the layout first to confirm the main line can handle extra flow from the kitchen.
Yes, it does. The toilet must sit above the waste outlet in the floor, and the natural fall carries the waste without a pump. If you raise the new toilet height, drainage works easier.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Yarmouk
Other work we do in the same area.
Back to Sanitary fixture installation