Plumbing and sanitary
Ramadan Drain CleaningShower cabin installation in Yarmouk
Shower cabin installation in Yarmouk means understanding that your flat has fixed flooring and narrow corridors, and the glass has to come through the door in one piece. Yarmouk is an older residential area in Kuwait, most flats are newly furnished or renovated, and bathrooms tend to be compact.
Leak signs
When water escapesthe cabin.
Water getting out has four known routes.
01
Wet tiles outside the cabin
Wet floor after every shower means water is escaping at the seal along the tray edge or under the door threshold. The glass itself is rarely the cause.
02
The tray flexes underfoot
If the tray gives under you when you stand on it, it is not fully supported underneath. That constant flex opens the seal around it and works the waste connection loose.
03
The door drags or will not shut
A door catching on the floor or not closing tightly means the profile was fitted out of square or the tray is not level. A door that does not close lets water out of the gap every time it is used.
04
The waste is slow
Water standing in the tray after the shower is off means the waste below has not enough fall, or its trap is packed with hair and soap. Standing water finds another way out.
This area
What setsthis area apart
Yarmouk flats are in older and mid-age apartment blocks, with bathrooms that have ceramic or marble tiling already in place. When we fit a shower cabin, we first check whether the floor is level and whether there is old dampness underneath the tiles. The waste from the cabin sits close to the bathroom wall always, but the floor trap and the original falls underneath have to drain properly. If the floor trap is old or partially blocked, a new cabin will not solve water pooling outside it.
Yarmouk is in Kuwait governorate, an older residential area with apartment blocks mostly built in the eighties and nineties.
Most Yarmouk flat bathrooms sit at corridor level, so the floor trap beneath must be sound to prevent moisture seeping into the passage.
In short
The cabin work.
Service
Shower cabin installation and leak repair
Included
Tray, waste and trap, profiles, door, sealing
Types
Complete cabins, and glass enclosures on a separate tray
Where it applies
Bathrooms in houses, flats and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From the trayto the door.
Bottom upwards, and each stage is tested before the next one starts.
We set the waste first
The waste outlet and its fall are checked first, and we confirm the tray trap sits comfortably beneath, because a tray fitted over a bad waste comes up again.
We support and level the tray
The tray is fully supported underneath and levelled, so it cannot flex under weight and falls slightly towards the waste so water leaves on its own.
We fit profiles and glass
The profiles are fixed to the wall truly vertical, because any lean in them shows up in the door at once and makes it drag or refuse to close.
We test before sealing
The shower runs, the water is left to move, and the floor around the cabin is watched. Only then does the silicone bead go on, on the inside.
Common questions
Questions about Shower cabin installation in Yarmouk
If the floor is level and dry, we usually fit without breaking tiles. But if there is dampness under the tiles or the floor is uneven, we must lift the tiles and fix the base first.
The cabin waste collects in the bathroom floor trap, which is connected to the flat's main stack. If the stack is long or narrow, water may drain slower but it will still run away.
Nearby areas
More areas for Shower cabin installation
Same service, in nearby areas.
Other services
Other services in Yarmouk
Other work we do in the same area.
Back to Shower cabin installation