Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Ministries Area
Sanitary fixture installation in the Ministries Area means connecting toilets, sinks and exhaust fans in large government buildings that may have dozens of floors. The Ministries Area has older and newer buildings side by side, and the piping runs on roofs and inside the walls.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Government buildings in the Ministries Area rely on vertical waste stacks rising from the foundation to the roof, and water arrives from roof-mounted tanks or pump stations in the basement. Installing a new tap or toilet in an office or bathroom requires us to check the waste stack serving that floor and confirm the water pipe has steady pressure. Older buildings use copper or old iron pipe, newer ones use PVC and PPR, and each needs a different fitting approach.
The Ministries Area is in Hawalli governorate and houses the main government buildings and state administrative offices.
Waste stacks in ministry buildings serve multiple floors at once, so installing a new fixture requires proper sizing of the waste pipe.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Ministries Area
Yes, upper floors are no problem as long as the main line is sound and water pressure is adequate. We ensure the waste pipe slopes properly from the floor downwards.
Possible, but we inspect the old pipe first. If there is scale or rust that reduces pressure or causes leaks, we will recommend either replacement or chemical flush.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Ministries Area
Other work we do in the same area.
Back to Sanitary fixture installation