Water heaters
Ramadan Drain CleaningHeating element and thermostat in Rawda
Heating element and thermostat in Rawda need precise separate electrical measurement because the fault may sit in either one. Rawda is a quiet residential area in Kuwait with villas and flats surrounded by parks and green spaces, electric heaters are common in bathrooms and kitchens, and faults show as slow heating or complete absence of warmth.
Which part
Element, orthermostat.
These signs point at the part before anyone takes a cover off.
01
Warm but never hot
The element is still working but the heat is not reaching the water, because the sheath is wrapped in a scale layer that insulates it. The water feels tepid and never quite gets to a comfortable shower temperature however long you wait.
02
The temperature drifted
The tank used to give the same temperature at the same setting, and now it is colder or hotter with the dial untouched. The thermostat has drifted off its reading, and that is a part you replace rather than adjust.
03
A new element failed early
When an element burns out again soon after it was changed, the part itself is rarely the reason. A floor full of sediment or a thermostat that will not switch off will cook any new element, which is why both get checked with every replacement.
04
A weep at the flange
Water seeping around the plate after a change means the gasket is tired or was seated on a face that was not cleaned. This is not the tank leaking. A fresh gasket, a cleaned face and even tightening across the bolts settles it.
This area
What setsthis area apart
Rawda has single villas and flats in mixed blocks, with electric heaters spread across rooftops, kitchens and bathrooms. Modern Rawda homes may have upgraded heaters with better thermostats, and older homes may have weak elements needing replacement. We start by measuring voltage at the thermostat first, and if current reaches it correctly, we move to the element and measure its current and resistance separately, so we pinpoint which has failed.
Rawda sits in Kuwait governorate, a quiet, green residential area with villas and flats alongside Rawda Park and Rawda Co-op.
Rawda heaters require separate thermostat measurement from element measurement, because each can fail independently at different rates.
Parts at a glance
The two parts.
Service
Heater element and thermostat replacement
Parts
Element, thermostat, thermal cut out and flange gasket
Fits
Central cylinders and small wall heaters alike
Before fitting
We measure the old part and inspect the tank floor
Hours
Daily, 6:00 in the morning to 12:00 midnight
Fitting
How a part ischanged.
Four steps, and each one is there for a reason rather than out of habit.
We confirm the part
Before anything is undone we read the element, the thermostat and the cut out. The meter names the failed part, and some heaters come back with both of them gone.
We drop the water level
The element comes out of a flange on the body of the tank, so the water has to fall below it first. A thermostat is reached from outside and needs none of this.
We fit an element that matches
The replacement has to be the same length, the same power and the same connection as the one that came out, so it clears the tank floor and suits the circuit already there.
We tighten evenly and pressure test
A new gasket goes on, the bolts are tightened evenly and in turn, and the tank is filled so we can watch the flange under pressure before the power goes anywhere near it.
Common questions
Questions about Heating element and thermostat in Rawda
The thermostat is what tells the element to run or stop. If the thermostat is broken or receives no current, the element will not work even if it is fine, so we check the thermostat first.
Water takes longer to warm or feels less hot even over the same period. We measure current flowing through the element in amps, and low current means the element is weakening and needs replacement.
Other services
Other services in Rawda
Other work we do in the same area.
Back to Heating element and thermostat