Water heaters
Ramadan Drain CleaningHeater repair and service in Rawda
Heater repair and service in Rawda serves independent villas in a leafy, densely residential area. Rawda is a quiet residential district with parks and trees, and most villas here are relatively modern construction but heaters need regular periodic maintenance like anywhere else.
Scale warnings
The heater tells youit needs a flush.
Three signs that show up long before a heater quits, and all of them come from the same cause.
01
Knocking from the tank
When sediment settles over the element, the water trapped underneath boils and forces its way up through the layer as bubbles. That is the knocking or rumbling you hear from the cylinder while it heats, and it is the first call for a flush.
02
The first draw runs cloudy
Hot water that comes through cloudy or carries white grit and then clears is loose sediment moving off the tank floor. A rusty tinge is a bigger story: the internal protection has been used up and the steel has started to corrode.
03
It takes longer than it did
The tank needs longer to reach the same temperature and nothing about how you use it has changed. Scale on the element blocks heat from reaching the water, so the heater draws power for longer and gives you less back.
This area
What setsthis area apart
Villas in Rawda near Rawda Park and the co-operative each have a tank heater on the roof or beside the villa. Hot water from the heater travels through relatively new copper and iron pipes, but scale still accumulates at the same rate. Service includes checking the thermostat and heating elements, and draining sediment from the tank yearly. Newer Rawda villas may have a thermal expansion tank, so we need to make sure it functions correctly.
Rawda sits in Kuwait governorate, a leafy, densely residential area with independent villas and public parks.
Most Rawda villas are relatively new and easy to service, but the thermal expansion valve must be checked at least once a year.
Servicing at a glance
What a servicecovers.
Service
Servicing, flushing and repair of water heaters
Included
Draining and flushing, descaling the element, checking the protection rod and the valves
Heaters covered
Central cylinders and the small bathroom heaters
Best time
Before winter, and before the first run after a long break
Hours
Daily, 6:00 in the morning to 12:00 midnight
The service, in order
How the serviceruns.
The same four steps every time, and none of them gets skipped.
We isolate and drain
The power goes off, the cold feed is closed and the drain valve opens until the cylinder is empty. What comes out last tells us how much sediment has collected on the floor.
We flush the floor
With the tank empty we open the cold feed again so the incoming water stirs the sediment and carries it out through the drain. That is repeated until the water leaving runs clear.
We pull and descale the element
The element comes out of its flange and the scale crust is cleaned off the sheath. We also check how much of the protection rod is left, since that rod is what keeps the tank wall from rusting.
We refit and test the valves
The element goes back with a new gasket, the tank is filled and vented, and the safety valve is worked open and shut. Then the power returns and we watch the temperature settle.
Common questions
Questions about Heater repair and service in Rawda
When water heats it expands and increases pressure in the tank. The expansion valve releases excess water so the tank and pipes do not burst. If the heater is swollen and water drips from the overflow pipe, the valve is not working properly.
Yes, you can turn it off or set it to a very low level. But if you turn it back on after a month or two, do it slowly because the tank might have trapped air inside.
Other services
Other services in Rawda
Other work we do in the same area.
Back to Heater repair and service