Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Salwa
Sanitary fixture installation in Salwa requires knowing the pipe layout in the area, as the residential blocks are old and lines are sometimes tight. Salwa is a dense residential zone with closely packed flats, and nearly every house shares a deep waste line running under the street.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Most Salwa flats were built in the eighties and nineties, bathrooms are small and the visible pipes under the floors sit close to the surface. If you want a new bath in place of an old sink, we have to work in tight spaces and be careful when we cut. The main waste line under the flat is off-limits, but we make sure your bathroom's secondary pipe slopes right toward the internal outlet.
Salwa sits in Hawalli governorate, an older dense residential area with small flats and tight pipe runs.
Secondary waste pipes in Salwa flats are narrow and sit near the surface, so any new fixture must be tested with light water pressure before the floor is sealed.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Salwa
We choose a narrower sink or wall-hung model so it does not block the passage. We do not cut the waste pipe if it feeds a main outlet.
If we are not careful, drainage backs up and bad smells come through. That is why we check first where the pipe runs and the main line, and only cut if there is no other way.
Other services
Other services in Salwa
Other work we do in the same area.
Back to Sanitary fixture installation