Plumbing and sanitary
Ramadan Drain CleaningValve repair in Salwa
Valve repair in Salwa requires careful tracking, because the flats have long hallways and main valves may sit far from the kitchen. Salwa is an older flat district in Hawalli, and the single main valve for each unit often hides in a remote corner or under other pipework.
Valve symptoms
When a valveneeds work.
A valve is a part that sits still, which is why you discover its fault at the worst moment.
01
Closed, and water still comes
You turn the handle until it stops and it feels shut, but the tap still gives a thin flow. That means the closing part inside no longer meets its seat fully, because of deposits or wear.
02
Seized and will not turn
A valve nobody has turned for a long stretch sticks as deposits build around the spindle. Forcing it snaps the handle or opens the spindle up, and you end up with a leak where there was none.
03
A weep at the handle
A drop appearing around the spindle when you open or close it. The packing that seals the spindle has tired, and that is often repaired without changing the whole valve if the body is sound.
04
The fixture has no valve
A basin, a toilet or a washing machine with no valve of its own means any small repair stops water to the whole house. Fitting an angle valve to each fixture changes every future repair.
This area
What setsthis area apart
Salwa's construction is relatively old, and the flats have main valves of varying age, some old Egyptian types that are heavily corroded. The hallways are long and the flat's meter sometimes sits under the stairs or near the rear door. When we search for the valve we look under every old pipe run, because it may be buried under dust or rust deposits. If the valve fails and needs replacing in a cramped hallway, we work slowly and ensure we do not damage other visible pipework.
Salwa sits in Hawalli governorate, an older flat district near the Salwa co-operative.
Water valves in Salwa flats often need regular cleaning because aged pipes leave sediment behind.
In short
The valve work.
Service
Water valve repair, replacement and fitting
Types
Main valves, branch valves, angle valves at fixtures
Where they sit
At the tank, on the roof, in the yard, under fixtures
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From above itto below it.
Changing a valve needs another valve above it, and that is the first thing we confirm.
We find the upstream shut off
We look for a valve able to stop the water before the failed one, and if there is none we shut off at the tank outlet or the supply point itself.
We drain before opening
The lowest tap on the run is opened so whatever is left in the pipework drains out, because unscrewing a valve on a full line soaks the area and makes the work harder.
We repair or replace
If the weep is only at the spindle and the body is sound, the packing is renewed. If the closing part is worn or the body is tired, a new valve goes in its place.
We open and close it twice
Pressure comes back and the valve is opened and closed several times with a tap watched after it, because a valve that works once does not necessarily close properly the next time.
Common questions
Questions about Valve repair in Salwa
In older Salwa flats, valves are sometimes under the stairs or near the meter in the back corner. We come and locate it quickly.
We recommend a brass valve with a hexagon fitting, which lasts longer in damp hallways because it resists corrosion. We fit it properly and test it before we leave.
Other services
Other services in Salwa
Other work we do in the same area.