Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Sabah Al-Nasser
Sanitary fixture installation in Sabah Al-Nasser involves modern houses and flexible line distribution. The area sits near Sixth Ring Road, with new villas and developments where water and waste are distributed to allow relatively straightforward addition of new fittings.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Sabah Al-Nasser is a modern development; the co-op near Sixth Ring Road is the landmark. Risers and falls in new villas run at consistent intervals, and a second bathroom or extra toilet can usually be fitted without major trouble. Floors and walls in newer homes are thicker and stronger, making it easier for a technician to find a safe route for new pipes. A first survey of the riser, floor and walls may show the existing lines are enough or need extending.
Sabah Al-Nasser sits in Farwaniya governorate near Sixth Ring Road, with relatively new villa developments.
Sabah Al-Nasser villas were built to uniform pipe distribution standards, reducing surprises when locating a new branch point.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Sabah Al-Nasser
If pipes are nearby and the position is clear, we can finish in one visit. But inspection comes first, and if we need breaking or a new run, it might take more than one call.
We check the pressure and main supply and tell you if it can feed the new tap without reducing pressure elsewhere. Newer villas are usually in a better position.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Sabah Al-Nasser
Other work we do in the same area.
Back to Sanitary fixture installation