Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Khitan Al-Jadida
Sanitary fixture installation in Khitan Al-Jadida works with modern designs and properly organized spaces. Khitan Al-Jadida is a relatively new residential area with new flats and villas, and its plumbing lines are uniform and easy to measure and fit.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Khitan Al-Jadida was built in recent years, and its flats and villas have similar designs with strong modern foundations. Bathrooms and kitchens are square and regular, with waste outlets at standard known points. Walls are concrete or strong plasterboard, and fixing is easy with standard or chemical anchors depending on wall type. Water and drain lines are clearly marked, and spacing between outlets is constant across all flats. If you want to add an extra sink or second bathroom close to the existing one, the distance and height align precisely.
Khitan Al-Jadida lies in Farwaniya governorate, a modern residential area with contemporary flats and villas.
Flats in Khitan Al-Jadida have uniform foundations and internal outlet heights follow a standard across all units.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Khitan Al-Jadida
We measure the distance from the existing line and height from floor, and most times we can connect the new pipe to the existing outlet with a simple bend. The new counter and sink fit easily onto the old line if its position is suitable.
Yes, replacement is straightforward. We isolate the old line and connect the new one at the same point. If the size differs slightly we extend the pipes a little, and the main line stays the same.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Khitan Al-Jadida
Other work we do in the same area.
Back to Sanitary fixture installation