Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Qadisiya
Sanitary fixture installation in Qadisiya, near Kuwait Sports Club stadium, covers a mix of older villas and newer flat buildings. Every sanitary fitting needs clean water supply and a separate waste line, all balanced in height with each other.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Qadisiya has diverse housing, with old villa soil lines running long distances to a main inspection chamber underground, and newer flats with their own vertical stacks. If you fit a bidet or laundry sink in an older villa, the original outlet height has little room to move. In newer flats the pipes are exposed or chased in newer walls, so we have more freedom placing the fixtures, but we must ensure the fall towards the main line is correct.
Qadisiya sits in Kuwait governorate, a residential area mixing villas and flats near Kuwait Sports Club stadium.
Old Qadisiya villas have deep inspection chambers, while newer flats have short, above-ground waste stacks.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Qadisiya
Because the main line in a Qadisiya villa sits deep underground, and the outlet must sit above any water in that line, or else dirty water backs up when we clean or in hot weather.
A villa has one shared line for the whole house, a flat has its own line in the stack. In a villa we start at the chamber, in a flat we start from the riser above or from the horizontal chase in the wall.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Qadisiya
Other work we do in the same area.
Back to Sanitary fixture installation