Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Khalidiya
Sanitary fixture installation in Khalidiya starts by choosing the basin or toilet and ensuring its position suits the existing pipes in the house. Khalidiya is a villa area with uniform building standards, and sanitary fixtures are typically installed in separate bathrooms and organized kitchens.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Khalidiya villas are relatively older and built to the same standard design, with a master bathroom near the main bedrooms and a second or third bathroom for guests or the maid. Pipes in these villas usually run inside walls or beneath tile in a semi-fixed pattern. When we install a new basin or toilet, we trace the wall carefully to avoid hitting a hidden water or waste line. Roof tanks sit on top, and falls from bathrooms and kitchen drain into one inspection chamber near the gate.
Khalidiya is in Kuwait governorate, a quiet villa residential area near Khalidiya Co-op and Khalidiya Park.
Most Khalidiya villas are built some years ago, so older pipes may be larger than current standards.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Khalidiya
We first confirm the existing waste line is clear of blockages and water reaches the bathroom easily from the tank. If pipes are narrow, we can widen them or run a new line.
No, if you want only cold water for a guest basin or second bathroom, we run cold only. But if a hot water line already exists nearby, we recommend using it for better service.
Other services
Other services in Khalidiya
Other work we do in the same area.
Back to Sanitary fixture installation