Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Rai
Sanitary fixture installation in Rai starts with measuring the wall and verifying that water pressure is enough for the whole property. Rai is a commercial and mixed area with malls and apartments, and connections here run through bigger-diameter pipes so pressure doesn't drop. Any new sink or toilet must be fitted at a height that matches the system's pressure.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Rai has modern residential buildings next to malls and office towers, and apartments in tall buildings need fixtures at different heights depending on the floor. Pressure in Rai is usually strong because the area is newly built, but when we install new equipment we test the pressure with a gauge first. Bathrooms in modern flats are laid out horizontally, and outlets are marked on the engineering drawings. When we fit a sink on the fiftieth floor, for example, the outlet must handle the water height coming from the roof tank.
Rai sits in Kuwait governorate, a commercial and mixed area with malls and modern residential towers.
Water pipes in Rai towers are insulated and under higher pressure than older residential areas, so installation requires a pressure test before starting.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Rai
Yes, but we need to know the exact floor and what pressure reaches the unit. We test the pressure with a gauge before fitting anything, and in Rai towers the pressure is usually adequate for all fixtures.
We bring an extension pipe in the same diameter and fit it at the correct height. The solution depends on the wall and existing pipes, and the cost varies with how far we extend and whether there are obstacles in the structure.
Other services
Other services in Rai
Other work we do in the same area.
Back to Sanitary fixture installation