Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Rawda
Sanitary fixture installation in Rawda starts by understanding the house layout and the water and waste lines running deep below ground. Rawda is a quiet residential area in Kuwait with villas and flats in leafy neighbourhoods. Each house has its own water and waste lines, and waste drops to an independent inspection chamber away from neighbouring properties.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Rawda has villas and flats, some older houses near Rawda Park and quiet streets. Villas in Rawda are often modern with good layout, and flats may be in older tower blocks. Water and waste lines in modern villas are planned and in place before building, but older flats need careful inspection. When we install a basin or toilet or water heater near the leafy Rawda area, we check that the walls can carry the load and pipes are safe. Modern villas are easier to fit, but older flats and houses may need pipe adjustments or wall strengthening.
Rawda sits in Kuwait governorate, a quiet residential area with villas and flats on independent waste systems per property.
Modern villas in Rawda have high-quality copper or plastic pipes, while older flats may need old pipes replaced.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Rawda
Yes, modern villas in Rawda are planned from the start with pipes installed before finishing. We work on lines that are already there and fit the fixtures to them. But we must check that the lines are clear and that water and waste run correctly.
The cost to replace pipes depends on line length and location. We inspect the pipes first and tell you what needs changing. Some old flats need complete line replacement, others only a small section. You should know that costs may be high but worth it because new pipes last long.
Other services
Other services in Rawda
Other work we do in the same area.
Back to Sanitary fixture installation