Plumbing and sanitary
Ramadan Drain CleaningMixer and faucet repair in Rai Industrial
Mixer repair in Rai Industrial is routine work because factories and workshops there cycle the water pressure constantly, and mixer cartridges block up fast. Rai Industrial is a commercial and light industrial zone in Farwaniya next to The Avenues Mall, and the shops and offices run multiple sinks.
Mixer symptoms
Four cases wesee often.
Each one of these points at a different part inside the mixer.
01
It drips after closing
If it keeps dripping with the handle fully closed, the ceramic discs inside the cartridge no longer meet cleanly. A single grain of grit is enough to score that face and keep the drip going.
02
The handle has gone stiff
A mixer that needs force to move has lost the grease inside it, or deposits have worked between the discs. Forcing it keeps breaking the cartridge, and you end up changing the mixer instead of a part.
03
The flow sprays sideways
When the flow breaks up and sprays to the sides, the small aerator at the tip is partly blocked. It is the easiest case of all, cleared by unscrewing the aerator and cleaning or replacing it.
04
Hot and cold are swapped
You open it towards cold and hot arrives, or the other way round. This follows a new installation with the two supplies reversed, or a cartridge refitted the wrong way up. The correction is simple and does not need a new mixer.
This area
What setsthis area apart
Most buildings in Rai Industrial are warehouses, workshops, showrooms and offices, and the mixers and faucets take heavy daily use. Cartridges clog fast if the water is dirty or the piping network itself has sediment. We pull the cartridge, inspect it, and if scale is heavy we flush the line a bit before fitting the new one. Shops along the main street have better water pressure than flats, but constant use wears the cartridge quicker.
Rai Industrial sits in Farwaniya governorate, a commercial and light industrial zone adjacent to The Avenues Mall.
Workshop and warehouse mixers in Rai Industrial see heavier use than home kitchen mixers, so the cartridge wears faster.
In short
The mixer work.
Service
Kitchen and bathroom mixer and tap repair
The parts
Ceramic cartridge, rubber rings, aerator, flexible tails
Types
Single lever, two handle, wall mounted, and hand shower
Where it applies
Kitchens and bathrooms in houses, flats and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the handleto the test.
Careful work on small parts, and all of it above the basin.
We close both angle valves
A mixer has two supplies, hot and cold, and both have to be closed. We then open the mixer to release the pressure still held in the two tails.
We lift the handle off
The handle is held by a small screw hidden under a plastic cap, and beneath it a ring clamps the cartridge. That comes off with the right tool so the mixer body is not scarred.
We change the cartridge
The old cartridge comes out and its seat is cleaned of deposits, because a new cartridge dropped onto a dirty seat gives you the same drip again before long.
We open it and check both
Both valves open, we run hot, cold and every position between, and we look under the basin while it runs to be sure the tails are not weeping.
Common questions
Questions about Mixer and faucet repair in Rai Industrial
If the cartridge is stuck or clogged with scale, it cannot blend hot and cold water properly. Replacing the cartridge restores mixing so you get the temperature you want.
If the piping has sediment or dirty water, even a new cartridge clogs quickly. We inspect and flush the line properly before fitting a replacement.
Nearby areas
More areas for Mixer and faucet repair
Same service, in nearby areas.
Other services
Other services in Rai Industrial
Other work we do in the same area.
Back to Mixer and faucet repair