Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Rai Industrial
Sanitary fixture installation in Rai Industrial covers restrooms and basins for shops, warehouses and offices. Rai Industrial is next to The Avenues Mall and holds storage sheds and commercial buildings, each with its own floor level and waste line, some newer and some older.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Commercial and industrial buildings in Rai have different floor heights and drainage routes than homes. A warehouse floor might be raised or sunken by design, and waste lines run through one or more inspection chambers before exiting. Shop and office restrooms need basins close to the wall and the toilet in a fixed spot, and every piece must slope toward the waste outlet. Newer buildings have flexible PVC pipework, older ones have heavy cast iron, so the fit-up changes.
Rai Industrial sits in Farwaniya governorate next to The Avenues Mall, a commercial and industrial zone with warehouses, shops and offices.
Most commercial buildings in Rai Industrial have multiple waste outlets and more inspection chambers than residential flats.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Rai Industrial
We need to see exactly where the waste line is, under or above the floor slab. A raised floor may need longer pipes or a drain pump, and the fixture still has to sit at the right angle.
A shop usually has a small restroom with one basin near the wall, but a warehouse might have multiple basins or a toilet far from the main line, so we need longer pipe runs and better ventilation.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Rai Industrial
Other work we do in the same area.
Back to Sanitary fixture installation