Plumbing and sanitary
Ramadan Drain CleaningMixer and faucet repair in Ministries Area
Mixer and faucet repair in the Ministries Area focuses on government buildings and old office blocks near the Civil Service Commission. The Ministries Area in Hawalli has very old service buildings, and the mixers are heavy-duty water-saving industrial types that need regular maintenance.
Mixer symptoms
Four cases wesee often.
Each one of these points at a different part inside the mixer.
01
It drips after closing
If it keeps dripping with the handle fully closed, the ceramic discs inside the cartridge no longer meet cleanly. A single grain of grit is enough to score that face and keep the drip going.
02
The handle has gone stiff
A mixer that needs force to move has lost the grease inside it, or deposits have worked between the discs. Forcing it keeps breaking the cartridge, and you end up changing the mixer instead of a part.
03
The flow sprays sideways
When the flow breaks up and sprays to the sides, the small aerator at the tip is partly blocked. It is the easiest case of all, cleared by unscrewing the aerator and cleaning or replacing it.
04
Hot and cold are swapped
You open it towards cold and hot arrives, or the other way round. This follows a new installation with the two supplies reversed, or a cartridge refitted the wrong way up. The correction is simple and does not need a new mixer.
This area
What setsthis area apart
The government buildings, the Diwan and ministry offices have heavy-duty industrial mixers fitted on thick copper pipes with very high pressure. The cartridge in these government mixers wears faster than home models because the pressure and water force are intense. We remove the old cartridge and fit a new industrial one rated for high pressure, and often we clean the aerator from limescale because these official areas use hot and cold water heavily.
The Ministries Area sits in Hawalli governorate, a central government zone holding official buildings, the Diwan and Civil Service Commission offices.
Ministry and government building mixers run on very high water pressure and need industrial-grade cartridges with reinforced seals.
In short
The mixer work.
Service
Kitchen and bathroom mixer and tap repair
The parts
Ceramic cartridge, rubber rings, aerator, flexible tails
Types
Single lever, two handle, wall mounted, and hand shower
Where it applies
Kitchens and bathrooms in houses, flats and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the handleto the test.
Careful work on small parts, and all of it above the basin.
We close both angle valves
A mixer has two supplies, hot and cold, and both have to be closed. We then open the mixer to release the pressure still held in the two tails.
We lift the handle off
The handle is held by a small screw hidden under a plastic cap, and beneath it a ring clamps the cartridge. That comes off with the right tool so the mixer body is not scarred.
We change the cartridge
The old cartridge comes out and its seat is cleaned of deposits, because a new cartridge dropped onto a dirty seat gives you the same drip again before long.
We open it and check both
Both valves open, we run hot, cold and every position between, and we look under the basin while it runs to be sure the tails are not weeping.
Common questions
Questions about Mixer and faucet repair in Ministries Area
No, a normal cartridge cannot handle high pressure and wears out quickly. We fit an industrial-grade cartridge with thick PTFE seals that resist pressure consistently.
The pipes are usually fine, but the aerator itself has clogged with limescale. We remove the aerator, clean it with water and vinegar, refit it, and the pressure returns.
Nearby areas
More areas for Mixer and faucet repair
Same service, in nearby areas.
Other services
Other services in Ministries Area
Other work we do in the same area.
Back to Mixer and faucet repair