Plumbing and sanitary
Ramadan Drain CleaningMixer and faucet repair in Bidaa
Mixer and faucet repair in Bidaa starts with a quick check to see where the drip is or where the flow is weak. Bidaa is a residential area near the seafront with mid-range and older flats, and its mixers suffer from humidity and salt-spray corrosion.
Mixer symptoms
Four cases wesee often.
Each one of these points at a different part inside the mixer.
01
It drips after closing
If it keeps dripping with the handle fully closed, the ceramic discs inside the cartridge no longer meet cleanly. A single grain of grit is enough to score that face and keep the drip going.
02
The handle has gone stiff
A mixer that needs force to move has lost the grease inside it, or deposits have worked between the discs. Forcing it keeps breaking the cartridge, and you end up changing the mixer instead of a part.
03
The flow sprays sideways
When the flow breaks up and sprays to the sides, the small aerator at the tip is partly blocked. It is the easiest case of all, cleared by unscrewing the aerator and cleaning or replacing it.
04
Hot and cold are swapped
You open it towards cold and hot arrives, or the other way round. This follows a new installation with the two supplies reversed, or a cartridge refitted the wrong way up. The correction is simple and does not need a new mixer.
This area
What setsthis area apart
Flats in Bidaa are older and sit close to the Salmiya waterfront, and humidity and salt in the air corrode mixers and pipes even if the mixer is new. A cartridge in an old mixer can rust easily, and in cases of salty water, we need to check the whole line, not just the mixer itself. Kitchen faucets and connections here need extra care because hot water can wear them down fast.
Bidaa sits in Hawalli governorate, an older residential area near Salmiya seafront with traditional flats.
Mixers in Bidaa need regular checks for rust and salt scale more than other areas because of the seafront location.
In short
The mixer work.
Service
Kitchen and bathroom mixer and tap repair
The parts
Ceramic cartridge, rubber rings, aerator, flexible tails
Types
Single lever, two handle, wall mounted, and hand shower
Where it applies
Kitchens and bathrooms in houses, flats and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the handleto the test.
Careful work on small parts, and all of it above the basin.
We close both angle valves
A mixer has two supplies, hot and cold, and both have to be closed. We then open the mixer to release the pressure still held in the two tails.
We lift the handle off
The handle is held by a small screw hidden under a plastic cap, and beneath it a ring clamps the cartridge. That comes off with the right tool so the mixer body is not scarred.
We change the cartridge
The old cartridge comes out and its seat is cleaned of deposits, because a new cartridge dropped onto a dirty seat gives you the same drip again before long.
We open it and check both
Both valves open, we run hot, cold and every position between, and we look under the basin while it runs to be sure the tails are not weeping.
Common questions
Questions about Mixer and faucet repair in Bidaa
Yes, salt and humidity wear the cartridge and internal metals faster than regular water. If your mixer fails quickly, salty water is likely the reason.
Most of the time just the cartridge, but if the mixer body itself is rusted outside or cracked, you might need a full mixer replacement. We assess it first and let you know.
Other services
Other services in Bidaa
Other work we do in the same area.
Back to Mixer and faucet repair