Plumbing and sanitary
Ramadan Drain CleaningToilet and cistern repair in Bidaa
Toilet and cistern repair in Bidaa often involves a silent tank leak or a float valve that does not close properly. Bidaa is a residential area near the Salmiya seafront, with a mix of older and newer flats where bathrooms are roomier than in other districts but the pipework was installed quickly.
Toilet symptoms
Cistern and pansymptoms.
Four completely different cases, and each one sits on a different part.
01
A constant trickle inside
A running sound inside the cistern when nobody has flushed means the inlet valve is not closing fully, or the flush valve is passing into the pan. That water goes down the drain all day where you cannot see it.
02
The flush is weak
Needing to flush twice every time usually means the water level inside the cistern has dropped below where it should sit, or deposits are blocking the rim holes and killing the rush of water.
03
The pan rocks when used
Movement means the floor fixings have loosened or the floor under it is not flat. Constant rocking works the connection between the pan and the waste pipe loose, and the leak starts after that.
04
Water at the base
Wetness around the base has two possible sources: the seal between cistern and pan leaking from above, or the waste connection below the pan. Drying the area and watching where it returns tells them apart.
This area
What setsthis area apart
Bidaa has two types of flats: older ones near the waterfront from the 1970s and 80s with high narrow tanks, and newer flats inland with contemporary cisterns and modern plumbing. But in both types, when a flat sits close to the seashore, humidity enters the walls and corrodes flange bolts quickly. Cistern floats in Bidaa fail faster than elsewhere because of salt in the air.
Bidaa is a residential area in Hawalli governorate near the Salmiya waterfront.
Older flats in Bidaa near the sea have varied cistern heights and moisture affects repair work.
In short
The toilet work.
Service
Toilet pan and cistern repair
The parts
Inlet valve, float, flush valve, seal, pan connector
Types
Exposed cisterns, and concealed cisterns inside the wall
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the lid tothe last flush.
A cistern is read with the lid off, never guessed at from outside.
We lift the lid and read it
The water level inside tells us a lot: sitting low means the flush will be weak, sitting high enough to enter the overflow means the valve is not closing.
We split filling from flushing
We close the angle valve and watch the level. If it falls on its own, the flush valve is passing into the pan. If it holds, the fault is in the inlet valve.
We change the right part
An inlet valve, a float, a flush valve washer, or the large seal between cistern and pan. The part is replaced outright rather than adjusted.
We set it and flush it
The level is set to the mark, we flush it several times, and the base and the connections are checked dry before we leave.
Common questions
Questions about Toilet and cistern repair in Bidaa
Yes, salt corrodes the cistern metal faster. We replace the entire mechanism if rust reaches the water connections or float, rather than do a temporary patch job.
Not dangerous but it wastes a lot of water and your bill goes up. We service the tank itself first before replacing it entirely, checking the base and surface rust.
Other services
Other services in Bidaa
Other work we do in the same area.
Back to Toilet and cistern repair