Leak detection
Ramadan Drain CleaningWater tank leaks in Shuaiba
Water tank leak detection in Shuaiba begins by separating tank cracks from float or pipe leaks, since Shuaiba is a coastal industrial zone where the water is salty and causes rapid corrosion. Residential villas and buildings here have large supply and waste tanks, with pipes running across roofs exposed to direct sun and salt air.
Where to start
Where the levelis going.
Four signs that separate a leaking tank from the rest.
01
It drops with nobody using it
Mark the level at night and look at it in the morning before anyone uses water. A clear drop with no use means water is leaving the tank or a pipe off it, not being consumed.
02
Damp on the wall below
A line of damp or white salt running down the roof wall under the tank says water is leaving the tank or a fitting on it. A ground tank shows the same trace on the paving around it.
03
The overflow runs all day
If the overflow pipe is running while you are not filling, the float valve is not closing and the tank keeps filling and throwing it away. That is a real loss on the bill, but it is not a hole in the tank.
04
The pump fills more than usual
A pump that runs more often than it used to on the same usage says water is going missing between filling and using it, either in the tank or on the line after it.
This area
What setsthis area apart
Shuaiba is an industrial port south of Ahmadi, with residential buildings surrounded by industrial facilities and smoke. Tanks here corrode faster than elsewhere because salt and coastal humidity attack metals and concrete. Roof pipes are exposed to sun, wind and salt, so they rust, clog and leak faster. When checking for leaks, we start with float and overflow, and if we find moisture around the tank, we inspect pipes closely, especially joints and clamps. Old Shuaiba tanks often have multiple small cracks.
Shuaiba sits in Ahmadi governorate as an industrial port south of Ahmadi City, a coastal area where tanks face salt and moisture exposure.
Shuaiba tanks, whether metal or concrete, corrode from coastal salt and need more frequent checking than inland tanks.
The service
On the tank,in detail.
Service
Leak detection on water tanks and their outlets
Tank types
Plastic roof tanks and concrete ground tanks
We also check
The float valve, the overflow, outlet fittings and the pump valve
Method
A level test with the outlets isolated, then fittings and body
Coverage
Houses, chalets, blocks and complexes, across Kuwait
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we check
From the mark tothe cause.
Four steps, each one taking a possible cause off the list.
We mark the level and close the outlets
We mark the water level on the tank body and close the inlet and outlet valves, so the tank is shut and nothing can enter or leave it.
We read the level again
If the level drops while the tank is closed on both sides, the loss is in the tank body itself or in a fitting below the water line.
We open the outlets one at a time
If the level held while it was closed and dropped once the outlet was opened, the tank is sound and the loss is on the line after it, which is a pipework job.
We check the body and fittings
We go over the seams, the corners, the area round the outlet boss and the base, then the float valve and the overflow, and tell you the cause and what it needs.
Common questions
Questions about Water tank leaks in Shuaiba
Yes, salt eats through metals and concrete faster, so Shuaiba tanks and pipes fail sooner than in other areas. If your tank is metal, salt accelerates corrosion and perforation, and if concrete, salt breaks down the structure.
Internal rust weakens the tank walls and causes pinhole leaks that grow larger. If you see red or brown colour in the water or on the tank walls, replacement should be planned soon or at least check it weekly.
Nearby areas
More areas for Water tank leaks
Same service, in nearby areas.
Other services
Other services in Shuaiba
Other work we do in the same area.