Water heaters
Ramadan Drain CleaningHeating element and thermostat in Yarmouk
Heating element and thermostat problems in Yarmouk often start when the tank shuts down suddenly or the water just will not heat like it used to. Yarmouk is a mixed residential area of flats and villas where many water heaters are older installations, and the element needs meter testing before you buy a new one.
Which part
Element, orthermostat.
These signs point at the part before anyone takes a cover off.
01
Warm but never hot
The element is still working but the heat is not reaching the water, because the sheath is wrapped in a scale layer that insulates it. The water feels tepid and never quite gets to a comfortable shower temperature however long you wait.
02
The temperature drifted
The tank used to give the same temperature at the same setting, and now it is colder or hotter with the dial untouched. The thermostat has drifted off its reading, and that is a part you replace rather than adjust.
03
A new element failed early
When an element burns out again soon after it was changed, the part itself is rarely the reason. A floor full of sediment or a thermostat that will not switch off will cook any new element, which is why both get checked with every replacement.
04
A weep at the flange
Water seeping around the plate after a change means the gasket is tired or was seated on a face that was not cleaned. This is not the tank leaking. A fresh gasket, a cleaned face and even tightening across the bolts settles it.
This area
What setsthis area apart
Flats in Yarmouk need easy access to the heater, most of which sit on the roof or in a cupboard beside the outdoor kitchen. The heaters here run on current from the main villa supply or a separate meter, and the thermostat tells the element when to fire and when to stop. If the water gets warm but will not reach full heat, we measure the voltage with a meter and see whether the element needs replacing or the thermostat is broken.
Yarmouk sits in Kuwait governorate, a residential area with a mix of flats, villas and apartment blocks.
Older Yarmouk heaters need regular thermostat checks because the electrical supply is not always steady throughout the day.
Parts at a glance
The two parts.
Service
Heater element and thermostat replacement
Parts
Element, thermostat, thermal cut out and flange gasket
Fits
Central cylinders and small wall heaters alike
Before fitting
We measure the old part and inspect the tank floor
Hours
Daily, 6:00 in the morning to 12:00 midnight
Fitting
How a part ischanged.
Four steps, and each one is there for a reason rather than out of habit.
We confirm the part
Before anything is undone we read the element, the thermostat and the cut out. The meter names the failed part, and some heaters come back with both of them gone.
We drop the water level
The element comes out of a flange on the body of the tank, so the water has to fall below it first. A thermostat is reached from outside and needs none of this.
We fit an element that matches
The replacement has to be the same length, the same power and the same connection as the one that came out, so it clears the tank floor and suits the circuit already there.
We tighten evenly and pressure test
A new gasket goes on, the bolts are tightened evenly and in turn, and the tank is filled so we can watch the flange under pressure before the power goes anywhere near it.
Common questions
Questions about Heating element and thermostat in Yarmouk
Usually the element is tired or the thermostat is not working properly. We measure the voltage on both the element and thermostat with a meter and tell you which one needs replacing.
No, the thermostat should only cut the current when the water reaches the temperature you set. If the heater shuts down before the water heats up, the thermostat has a fault and needs meter testing.
Nearby areas
More areas for Heating element and thermostat
Same service, in nearby areas.
Other services
Other services in Yarmouk
Other work we do in the same area.
Back to Heating element and thermostat