Water heaters
Ramadan Drain CleaningHeating element and thermostat in Maqwa
Heating element and thermostat faults in Maqwa usually stem from extreme heat and dust from the oil fields. Maqwa is an industrial and residential area near the oil company fields, and heaters here work under harsh conditions.
Which part
Element, orthermostat.
These signs point at the part before anyone takes a cover off.
01
Warm but never hot
The element is still working but the heat is not reaching the water, because the sheath is wrapped in a scale layer that insulates it. The water feels tepid and never quite gets to a comfortable shower temperature however long you wait.
02
The temperature drifted
The tank used to give the same temperature at the same setting, and now it is colder or hotter with the dial untouched. The thermostat has drifted off its reading, and that is a part you replace rather than adjust.
03
A new element failed early
When an element burns out again soon after it was changed, the part itself is rarely the reason. A floor full of sediment or a thermostat that will not switch off will cook any new element, which is why both get checked with every replacement.
04
A weep at the flange
Water seeping around the plate after a change means the gasket is tired or was seated on a face that was not cleaned. This is not the tank leaking. A fresh gasket, a cleaned face and even tightening across the bolts settles it.
This area
What setsthis area apart
Villas and flats in Maqwa sit close to the oil fields, and heaters face dust and heat year-round. In these conditions, the element needs frequent checking because dust can enter the unit and block electrical contacts. The thermostat is also sensitive to dust and excessive heat, so it may not read temperature correctly. We open the heater and clean the parts of dust before testing.
Maqwa is a residential and industrial area in Ahmadi governorate, near the national oil company fields.
Maqwa heaters face more dust and heat than other areas, so the element and thermostat need checking more than once a year.
Parts at a glance
The two parts.
Service
Heater element and thermostat replacement
Parts
Element, thermostat, thermal cut out and flange gasket
Fits
Central cylinders and small wall heaters alike
Before fitting
We measure the old part and inspect the tank floor
Hours
Daily, 6:00 in the morning to 12:00 midnight
Fitting
How a part ischanged.
Four steps, and each one is there for a reason rather than out of habit.
We confirm the part
Before anything is undone we read the element, the thermostat and the cut out. The meter names the failed part, and some heaters come back with both of them gone.
We drop the water level
The element comes out of a flange on the body of the tank, so the water has to fall below it first. A thermostat is reached from outside and needs none of this.
We fit an element that matches
The replacement has to be the same length, the same power and the same connection as the one that came out, so it clears the tank floor and suits the circuit already there.
We tighten evenly and pressure test
A new gasket goes on, the bolts are tightened evenly and in turn, and the tank is filled so we can watch the flange under pressure before the power goes anywhere near it.
Common questions
Questions about Heating element and thermostat in Maqwa
Yes, dust from the oil fields enters the heater and blocks electrical connections. This makes them fail or stop working completely. We clean them of dust and test with a meter.
Because of dust and heat, we recommend checking every three months. Call us if you notice the water is not heating well or takes longer than usual.
Other services
Other services in Maqwa
Other work we do in the same area.
Back to Heating element and thermostat