Water heaters
Ramadan Drain CleaningHeating element and thermostat in Hawalli Midan
Heating element and thermostat work in Hawalli Midan must be fast because old residential flats here have ageing heaters with recurring faults. Hawalli Midan is in central Hawalli, an old mixed commercial and residential area near the marketplace. Most heaters here need replacement rather than repair, but we fix what we can first.
Which part
Element, orthermostat.
These signs point at the part before anyone takes a cover off.
01
Warm but never hot
The element is still working but the heat is not reaching the water, because the sheath is wrapped in a scale layer that insulates it. The water feels tepid and never quite gets to a comfortable shower temperature however long you wait.
02
The temperature drifted
The tank used to give the same temperature at the same setting, and now it is colder or hotter with the dial untouched. The thermostat has drifted off its reading, and that is a part you replace rather than adjust.
03
A new element failed early
When an element burns out again soon after it was changed, the part itself is rarely the reason. A floor full of sediment or a thermostat that will not switch off will cook any new element, which is why both get checked with every replacement.
04
A weep at the flange
Water seeping around the plate after a change means the gasket is tired or was seated on a face that was not cleaned. This is not the tank leaking. A fresh gasket, a cleaned face and even tightening across the bolts settles it.
This area
What setsthis area apart
Hawalli Midan has very old flats, most built thirty years ago, and the heaters are the same age as the buildings. When we pull a heater out in Midan, the wiring is corroded and the tank is crusted with mineral deposits. We test the element and thermostat but the thermostat usually won't work because moisture and salt have seized it. Old flats here have thin electrical wiring, so we watch the power load. If the heater starts to hiss and steam leaks, we tell residents to scrap it and buy new.
Hawalli Midan sits in Hawalli governorate, an old mixed marketplace and residential strip.
Most heaters in Hawalli Midan are over fifteen years old and most are not worth repairing from an efficiency standpoint.
Parts at a glance
The two parts.
Service
Heater element and thermostat replacement
Parts
Element, thermostat, thermal cut out and flange gasket
Fits
Central cylinders and small wall heaters alike
Before fitting
We measure the old part and inspect the tank floor
Hours
Daily, 6:00 in the morning to 12:00 midnight
Fitting
How a part ischanged.
Four steps, and each one is there for a reason rather than out of habit.
We confirm the part
Before anything is undone we read the element, the thermostat and the cut out. The meter names the failed part, and some heaters come back with both of them gone.
We drop the water level
The element comes out of a flange on the body of the tank, so the water has to fall below it first. A thermostat is reached from outside and needs none of this.
We fit an element that matches
The replacement has to be the same length, the same power and the same connection as the one that came out, so it clears the tank floor and suits the circuit already there.
We tighten evenly and pressure test
A new gasket goes on, the bolts are tightened evenly and in turn, and the tank is filled so we can watch the flange under pressure before the power goes anywhere near it.
Common questions
Questions about Heating element and thermostat in Hawalli Midan
If the heater is over fifteen years old, repair often does not pay. We tell the customer to buy new; the electricity bill pays back and we can focus on better work.
Yes, we must be careful. Thin wiring in old flats here may not handle extra load. We isolate power fully from the main switch before we remove the heater.
Nearby areas
More areas for Heating element and thermostat
Same service, in nearby areas.
Other services
Other services in Hawalli Midan
Other work we do in the same area.
Back to Heating element and thermostat