Which part
Element, orthermostat.
These signs point at the part before anyone takes a cover off.
01
Warm but never hot
The element is still working but the heat is not reaching the water, because the sheath is wrapped in a scale layer that insulates it. The water feels tepid and never quite gets to a comfortable shower temperature however long you wait.
02
The temperature drifted
The tank used to give the same temperature at the same setting, and now it is colder or hotter with the dial untouched. The thermostat has drifted off its reading, and that is a part you replace rather than adjust.
03
A new element failed early
When an element burns out again soon after it was changed, the part itself is rarely the reason. A floor full of sediment or a thermostat that will not switch off will cook any new element, which is why both get checked with every replacement.
04
A weep at the flange
Water seeping around the plate after a change means the gasket is tired or was seated on a face that was not cleaned. This is not the tank leaking. A fresh gasket, a cleaned face and even tightening across the bolts settles it.
This area
What setsthis area apart
Ardhiya villas are old and have small overhead heaters, with the element and thermostat serving the whole house from one landing or stairwell cupboard. Flats in Ardhiya are also old, with heaters distributed by building, sometimes one central heater or one per flat. The thermostat in Ardhiya does not need complex maintenance, but the element needs attention because heavy water scales it quickly. Reaching the heater in old villas may be from the roof or a stairwell store, while flats are slightly easier to access.
Ardhiya is a sprawling residential area in Farwaniya governorate, with mostly older buildings and simple electric heaters.
Ardhiya heaters age quickly due to heavy daily use and Kuwait's mineral-rich water.
Parts at a glance
The two parts.
Service
Heater element and thermostat replacement
Parts
Element, thermostat, thermal cut out and flange gasket
Fits
Central cylinders and small wall heaters alike
Before fitting
We measure the old part and inspect the tank floor
Hours
Daily, 6:00 in the morning to 12:00 midnight
Fitting
How a part ischanged.
Four steps, and each one is there for a reason rather than out of habit.
We confirm the part
Before anything is undone we read the element, the thermostat and the cut out. The meter names the failed part, and some heaters come back with both of them gone.
We drop the water level
The element comes out of a flange on the body of the tank, so the water has to fall below it first. A thermostat is reached from outside and needs none of this.
We fit an element that matches
The replacement has to be the same length, the same power and the same connection as the one that came out, so it clears the tank floor and suits the circuit already there.
We tighten evenly and pressure test
A new gasket goes on, the bolts are tightened evenly and in turn, and the tank is filled so we can watch the flange under pressure before the power goes anywhere near it.
Common questions
Questions about Heating element and thermostat in Ardhiya
Yes, an old element or one with scale coating loses power and takes longer to heat the water. If heating becomes very slow, we test it with a meter and say whether it needs cleaning or replacement.
Yes, it is possible. If the heater is very old or has not been cleaned in a long time, scale affects both the element and thermostat together. We test both and tell you which needs repair or replacement.
Nearby areas
More areas for Heating element and thermostat
Same service, in nearby areas.
Other services
Other services in Ardhiya
Other work we do in the same area.
Back to Heating element and thermostat