Water heaters
Ramadan Drain CleaningHeating element and thermostat in Anjafa
Heating element and thermostat faults in Anjafa hinge a lot on how they were first fitted, because the area was built quickly with villas and nobody paid attention to insulation. Anjafa is a residential area in Hawalli with small to mid-size villas, most from the nineties, and the heaters in them have not changed since day one. The element and thermostat work beyond capacity because insulation is poor and water cools from the roof tank.
Which part
Element, orthermostat.
These signs point at the part before anyone takes a cover off.
01
Warm but never hot
The element is still working but the heat is not reaching the water, because the sheath is wrapped in a scale layer that insulates it. The water feels tepid and never quite gets to a comfortable shower temperature however long you wait.
02
The temperature drifted
The tank used to give the same temperature at the same setting, and now it is colder or hotter with the dial untouched. The thermostat has drifted off its reading, and that is a part you replace rather than adjust.
03
A new element failed early
When an element burns out again soon after it was changed, the part itself is rarely the reason. A floor full of sediment or a thermostat that will not switch off will cook any new element, which is why both get checked with every replacement.
04
A weep at the flange
Water seeping around the plate after a change means the gasket is tired or was seated on a face that was not cleaned. This is not the tank leaking. A fresh gasket, a cleaned face and even tightening across the bolts settles it.
This area
What setsthis area apart
Villas in Anjafa sit very close together, and the heater usually sits on the roof or in a small room under the stairs. Water cools as it travels down a long line on the roof, so the thermostat tells the element to run more often. Electrical wiring in older Anjafa villas is weak, and sometimes the heater socket is loose because the original installation was rushed. When we inspect, we measure temperature right at the line before the heater arrives; if it is cool we know the line has poor insulation or the heater thermostat is sluggish. Small flats built between Anjafa villas put their heaters in whatever free space they have.
Anjafa sits in Hawalli governorate, a residential area with small to mid-size villas built in the nineties.
Heaters in Anjafa villas need more wire checking than other areas because the original install was not precise and electrical loads run high.
Parts at a glance
The two parts.
Service
Heater element and thermostat replacement
Parts
Element, thermostat, thermal cut out and flange gasket
Fits
Central cylinders and small wall heaters alike
Before fitting
We measure the old part and inspect the tank floor
Hours
Daily, 6:00 in the morning to 12:00 midnight
Fitting
How a part ischanged.
Four steps, and each one is there for a reason rather than out of habit.
We confirm the part
Before anything is undone we read the element, the thermostat and the cut out. The meter names the failed part, and some heaters come back with both of them gone.
We drop the water level
The element comes out of a flange on the body of the tank, so the water has to fall below it first. A thermostat is reached from outside and needs none of this.
We fit an element that matches
The replacement has to be the same length, the same power and the same connection as the one that came out, so it clears the tank floor and suits the circuit already there.
We tighten evenly and pressure test
A new gasket goes on, the bolts are tightened evenly and in turn, and the tank is filled so we can watch the flange under pressure before the power goes anywhere near it.
Common questions
Questions about Heating element and thermostat in Anjafa
Water cools in the long line running across the roof before it reaches the heater. We measure temperature where the line starts to confirm; you may need an extra line or insulation added.
If the electrical wires are old or the socket is loose, the thermostat cannot read voltage steady; it cuts on and off. We check the socket and wire, tighten the connections or swap the socket.
Nearby areas
More areas for Heating element and thermostat
Same service, in nearby areas.
Other services
Other services in Anjafa
Other work we do in the same area.
Back to Heating element and thermostat