When to replace
When a new heateris the answer.
Not every heater is worth repairing. These are the cases where a new one is the better call.
01
The body itself weeps
Water coming from the shell of the tank rather than a joint means the steel has gone through from the inside. Patching or welding that does not hold, and the answer is a new heater before the hole opens up and floods the room.
02
The same faults keep returning
An element that burns through one after another on a tank that is corroded inside is telling you the cylinder is the problem, not the parts. At that point we say plainly that replacing it beats carrying on repairing it.
03
It no longer fits the house
If the house has gained bathrooms or people since the heater went in and the cylinder never changed, the hot water runs short at the busy time of day. That is not a fault. It calls for more capacity or a different arrangement.
04
Fitted where nobody can reach
A heater squeezed into a tight space, or sitting over a plasterboard ceiling with no drip tray and no isolating valve near it, becomes a problem the day it needs servicing or starts to weep. Position is decided before the cylinder goes up, not after.
This area
What setsthis area apart
Salwa consists of medium-sized apartment blocks next to Sha'ab and near Mishref Park. The flats here have similar layouts but the old pipework varies unit to unit depending on past maintenance done by residents. Many flats cannot fit the heater in the kitchen due to space, so we mount it in a nearby cupboard or under the balcony. A balcony location needs extra insulation because of outside air, and the feed lines to the bathroom and kitchen must balance properly to avoid disrupting other appliances.
Salwa sits in Hawalli governorate, a residential area of medium-rise apartment blocks beside other housing districts.
Many Salwa flats are older design with tight balconies, so a heater under the balcony needs extra insulation against wind and cold air.
Install at a glance
What fitting covers.
Service
New central water heater supply and installation
Included
Mounting, pipework, isolating and safety valves, filling and commissioning
Where it applies
Houses, flats, chalets, blocks and complexes
Before we fit
We look at the position, the discharge and the existing circuit
Coverage
Every area of Kuwait, in all six governorates
Hours
Daily, 6:00 in the morning to 12:00 midnight
Start to finish
Fitting it, stepby step.
Four steps, and the power does not go back on until the last of them.
We look at the position first
Where the cylinder will sit, whether the wall carries its weight when it is full, where the nearest drain is, and what circuit already exists. All four are settled before a heater is ordered.
We isolate and remove the old one
Power off, feed closed, and the old cylinder drained right down before it is unbolted. A full tank is far heavier than people expect, and moving one full breaks the connections it hangs from.
We mount, pipe and connect
The tank goes on fixings sized for its filled weight, with the cold feed and the hot outlet run to an isolating valve and a safety valve, and the valve discharge taken somewhere a drip will be noticed.
We fill, vent and commission
The cylinder is filled and the air bled off, every joint is checked under pressure, and only then does the power go on, the temperature get set and a hot tap run in front of you.
Common questions
Questions about Central heater installation in Salwa
We survey the flat and run new copper or plastic pipes from the heater to the kitchen and bathrooms. A flat with no existing pipework takes longer because of routing through walls and floors.
We avoid damaging walls where we can, but if pipes must pass through the wall, we cut shallow channels and seal them neatly after routing the tubes.
Other services
Other services in Salwa
Other work we do in the same area.
Back to Central heater installation