When to replace
When a new heateris the answer.
Not every heater is worth repairing. These are the cases where a new one is the better call.
01
The body itself weeps
Water coming from the shell of the tank rather than a joint means the steel has gone through from the inside. Patching or welding that does not hold, and the answer is a new heater before the hole opens up and floods the room.
02
The same faults keep returning
An element that burns through one after another on a tank that is corroded inside is telling you the cylinder is the problem, not the parts. At that point we say plainly that replacing it beats carrying on repairing it.
03
It no longer fits the house
If the house has gained bathrooms or people since the heater went in and the cylinder never changed, the hot water runs short at the busy time of day. That is not a fault. It calls for more capacity or a different arrangement.
04
Fitted where nobody can reach
A heater squeezed into a tight space, or sitting over a plasterboard ceiling with no drip tray and no isolating valve near it, becomes a problem the day it needs servicing or starts to weep. Position is decided before the cylinder goes up, not after.
This area
What setsthis area apart
Sha'ab is a beachfront residential area with flats of different sizes and older buildings. Modern flats near the seafront have air conditioning and electric cylinders, while older Sha'ab properties have aged copper pipes that may already be pitted by salt damp. A central heater near the beach must sit in a dry spot away from moisture, and all fixings must be stainless steel. Old copper pipes often have pinhole leaks, so we inspect them closely before connecting the new heater.
Sha'ab sits in Hawalli governorate, a beachfront residential district with flats and houses facing the Gulf coast.
Humidity in Sha'ab is very high due to the seafront location, so heaters and pipes need reliable corrosion protection and proper sealing.
Install at a glance
What fitting covers.
Service
New central water heater supply and installation
Included
Mounting, pipework, isolating and safety valves, filling and commissioning
Where it applies
Houses, flats, chalets, blocks and complexes
Before we fit
We look at the position, the discharge and the existing circuit
Coverage
Every area of Kuwait, in all six governorates
Hours
Daily, 6:00 in the morning to 12:00 midnight
Start to finish
Fitting it, stepby step.
Four steps, and the power does not go back on until the last of them.
We look at the position first
Where the cylinder will sit, whether the wall carries its weight when it is full, where the nearest drain is, and what circuit already exists. All four are settled before a heater is ordered.
We isolate and remove the old one
Power off, feed closed, and the old cylinder drained right down before it is unbolted. A full tank is far heavier than people expect, and moving one full breaks the connections it hangs from.
We mount, pipe and connect
The tank goes on fixings sized for its filled weight, with the cold feed and the hot outlet run to an isolating valve and a safety valve, and the valve discharge taken somewhere a drip will be noticed.
We fill, vent and commission
The cylinder is filled and the air bled off, every joint is checked under pressure, and only then does the power go on, the temperature get set and a hot tap run in front of you.
Common questions
Questions about Central heater installation in Shaab
If we pick a dry location, use stainless fixings and seal it from salt damp, it will not rust quickly. But you should have it checked once a year to catch any corrosion early.
Old copper pipes in Sha'ab often have pinhole corrosion from salt and humidity. We pressure test them first, and if they are compromised we replace them with new stainless or quality plastic pipes.
Nearby areas
More areas for Central heater installation
Same service, in nearby areas.
Other services
Other services in Shaab
Other work we do in the same area.
Back to Central heater installation