Plumbing and sanitary
Ramadan Drain CleaningWater pump install and repair in Salhiya
Water pump install and repair in Salhiya means the building, whether flat, office or shop, relies on a tank and pump system, because Salhiya is a mixed commercial and residential area with towers and blocks packed close together. The pump is what distributes water to every unit in that building.
Pump symptoms
When the pumpis the cause.
A pump complains before it stops, and its symptoms are distinctive.
01
It cycles on and off fast
The pump starts, stops, and starts again while a single tap is open. That means the pressure vessel has lost the air cushion inside it, so the pump has no margin to rest between starts.
02
The noise changed suddenly
A different hum, a rattle, or a new whine. Fresh noise is usually air pulled into the suction side or a tired bearing, and both get worse if the pump is left running as it is.
03
It runs but nothing comes
The motor turns normally but the taps give nothing. The pump has lost its prime, or the tank is empty, or the suction valve is closed. Leaving it spinning dry burns the seal inside it.
04
It heats up and cuts out
The pump stops after a spell of running, then restarts once it cools. That is a thermal cut out doing its job, caused either by constant running from a leak on the line, or by a pump smaller than the house needs.
This area
What setsthis area apart
Salhiya around the Commercial Complex and the big hotel has many residential towers, office blocks, high apartment buildings and even old houses between towers. Tall towers and large blocks have heavy pumps and sometimes backup pumps, and each building has complex plumbing with rising mains and many branches running inside walls and ceilings. The crowding in Salhiya means tanks cannot be huge, and tank refill is faster, so the pump cycles on and off more often, which tires the motor quicker.
Salhiya sits in Kuwait governorate and contains tall residential towers, commercial buildings and offices around the Commercial Complex and hotel.
Most Salhiya buildings are over twenty storeys high, so their pumps operate under crushing pressure.
In short
The pump work.
Service
Water pump installation and repair
Types
Surface booster pumps, and submersible pumps inside a ground tank
The work includes
Pressure vessel, pressure switch, non return valve, float
Where it applies
Houses, flats, blocks, complexes and chalets
Electrical side
The electrical connection is an electrician's work, not ours
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From suctionto delivery.
A pump is read from both sides: what goes into it and what leaves it.
We check the tank first
The water level, the float and the outlet valve. A healthy pump on an empty tank gives exactly the same symptoms as a failed one.
We check the suction side
Any air drawn in through a joint on the suction side stops a pump pulling, even if not one drop of water leaks out of it. Joints are tightened and the non return valve is checked.
We check the vessel
The vessel holds air behind a rubber diaphragm, and that air is what stops the constant cycling. We check it, recharge it, and replace it if the diaphragm has split.
We run it and test at a tap
The pump runs and we open the furthest and highest tap in the house, because the result is measured there and not at the pump itself.
Common questions
Questions about Water pump install and repair in Salhiya
When the main pump breaks down or pressure drops sharply. The backup pump senses pressure and starts automatically, but sometimes the sensor fails so we must start it manually.
Pressure starts weak even when the pump runs, or the pump overheats fast, or you hear strange sounds like grinding or whining. These all mean the windings, bearings or seals are beginning to fail.
Other services
Other services in Salhiya
Other work we do in the same area.
Back to Water pump install and repair