Plumbing and sanitary
Ramadan Drain CleaningWater pump install and repair in Dasma
Water pump install and repair in Dasma handles an older area near the city centre with apartment blocks and rooftop tanks. Dasma is in Kuwait governorate and most housing is flats in five or six storey blocks, with pumps running constantly because the mains pressure is low.
Pump symptoms
When the pumpis the cause.
A pump complains before it stops, and its symptoms are distinctive.
01
It cycles on and off fast
The pump starts, stops, and starts again while a single tap is open. That means the pressure vessel has lost the air cushion inside it, so the pump has no margin to rest between starts.
02
The noise changed suddenly
A different hum, a rattle, or a new whine. Fresh noise is usually air pulled into the suction side or a tired bearing, and both get worse if the pump is left running as it is.
03
It runs but nothing comes
The motor turns normally but the taps give nothing. The pump has lost its prime, or the tank is empty, or the suction valve is closed. Leaving it spinning dry burns the seal inside it.
04
It heats up and cuts out
The pump stops after a spell of running, then restarts once it cools. That is a thermal cut out doing its job, caused either by constant running from a leak on the line, or by a pump smaller than the house needs.
This area
What setsthis area apart
Dasma blocks are older and their rooftop tanks are cramped and sometimes hard to reach. Underground pipes are aged and may leak or crack, and mains pressure is very weak so the pump must run efficiently. A new installation in an old block needs care because the roof may be uneven or not sturdy enough. We inspect the tank inside because old sediment may block the outlet or damage a new pump.
Dasma is an older residential district in Kuwait governorate near the city centre.
Mains pressure in Dasma is very low, so any house with a rooftop tank needs a powerful pump.
In short
The pump work.
Service
Water pump installation and repair
Types
Surface booster pumps, and submersible pumps inside a ground tank
The work includes
Pressure vessel, pressure switch, non return valve, float
Where it applies
Houses, flats, blocks, complexes and chalets
Electrical side
The electrical connection is an electrician's work, not ours
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From suctionto delivery.
A pump is read from both sides: what goes into it and what leaves it.
We check the tank first
The water level, the float and the outlet valve. A healthy pump on an empty tank gives exactly the same symptoms as a failed one.
We check the suction side
Any air drawn in through a joint on the suction side stops a pump pulling, even if not one drop of water leaks out of it. Joints are tightened and the non return valve is checked.
We check the vessel
The vessel holds air behind a rubber diaphragm, and that air is what stops the constant cycling. We check it, recharge it, and replace it if the diaphragm has split.
We run it and test at a tap
The pump runs and we open the furthest and highest tap in the house, because the result is measured there and not at the pump itself.
Common questions
Questions about Water pump install and repair in Dasma
There may be a leak or the old house fittings are blocked. We trace the line from tank to taps and check the valves and branch pipes. You might need the tank cleaned or an old pipe replaced.
The pump works but the pressure switch tells it when to stop. If the tank runs completely empty, the pump may suck air and stall. There needs to be some water in the tank at least.
Other services
Other services in Dasma
Other work we do in the same area.
Back to Water pump install and repair