Plumbing and sanitary
Ramadan Drain CleaningValve repair in Mishref
Valve repair in Mishref usually involves a valve that does not shut properly or brass pipe sweating under the tile. Mishref is a modern residential area with closely spaced apartment blocks and villas near Kuwait University and Mishref Park, and many homes still have original brass piping.
Valve symptoms
When a valveneeds work.
A valve is a part that sits still, which is why you discover its fault at the worst moment.
01
Closed, and water still comes
You turn the handle until it stops and it feels shut, but the tap still gives a thin flow. That means the closing part inside no longer meets its seat fully, because of deposits or wear.
02
Seized and will not turn
A valve nobody has turned for a long stretch sticks as deposits build around the spindle. Forcing it snaps the handle or opens the spindle up, and you end up with a leak where there was none.
03
A weep at the handle
A drop appearing around the spindle when you open or close it. The packing that seals the spindle has tired, and that is often repaired without changing the whole valve if the body is sound.
04
The fixture has no valve
A basin, a toilet or a washing machine with no valve of its own means any small repair stops water to the whole house. Fitting an angle valve to each fixture changes every future repair.
This area
What setsthis area apart
Mishref apartment buildings were constructed in phases, and the oldest are over fifty years old with brass piping soldered with old lead solder. Water valves in these buildings sit under sinks or in the passage cupboard, and most of them do not shut fully because hard-water lime has clogged the internal cavity. When we work on an old valve, we also check the pipe joints because soldered brass can weep from the joint itself.
Mishref sits in Hawalli governorate, a modern residential area near Kuwait University and Mishref Park, with apartment blocks and villas side by side.
Soldered brass pipe in Mishref lasts a long time, but the valves fitted to it after forty years need replacement because lime scale does not budge easily.
In short
The valve work.
Service
Water valve repair, replacement and fitting
Types
Main valves, branch valves, angle valves at fixtures
Where they sit
At the tank, on the roof, in the yard, under fixtures
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From above itto below it.
Changing a valve needs another valve above it, and that is the first thing we confirm.
We find the upstream shut off
We look for a valve able to stop the water before the failed one, and if there is none we shut off at the tank outlet or the supply point itself.
We drain before opening
The lowest tap on the run is opened so whatever is left in the pipework drains out, because unscrewing a valve on a full line soaks the area and makes the work harder.
We repair or replace
If the weep is only at the spindle and the body is sound, the packing is renewed. If the closing part is worn or the body is tired, a new valve goes in its place.
We open and close it twice
Pressure comes back and the valve is opened and closed several times with a tap watched after it, because a valve that works once does not necessarily close properly the next time.
Common questions
Questions about Valve repair in Mishref
Yes, especially if the solder is old or the water is very hard with heavy lime buildup. Sometimes the drip does not stop even when you fit a new valve, because the joint itself has no integrity. We tell the customer the pipe section needs replacement at that point.
If the valve is old, we replace it with a new brass or reliable alloy valve. If it is fairly new, we try unscrewing the handle and apply linen-seed oil or ream out the lime from the inside port. But if that does not work, replacement is the only option.
Other services
Other services in Mishref
Other work we do in the same area.