Plumbing and sanitary
Ramadan Drain CleaningValve repair in Ministries Area
Valve repair in the Ministries Area is critical because government buildings cannot shut water to the whole site without coordination. The Ministries Area holds large government offices and multi-storey buildings, and the valves are often hard to reach.
Valve symptoms
When a valveneeds work.
A valve is a part that sits still, which is why you discover its fault at the worst moment.
01
Closed, and water still comes
You turn the handle until it stops and it feels shut, but the tap still gives a thin flow. That means the closing part inside no longer meets its seat fully, because of deposits or wear.
02
Seized and will not turn
A valve nobody has turned for a long stretch sticks as deposits build around the spindle. Forcing it snaps the handle or opens the spindle up, and you end up with a leak where there was none.
03
A weep at the handle
A drop appearing around the spindle when you open or close it. The packing that seals the spindle has tired, and that is often repaired without changing the whole valve if the body is sound.
04
The fixture has no valve
A basin, a toilet or a washing machine with no valve of its own means any small repair stops water to the whole house. Fitting an angle valve to each fixture changes every future repair.
This area
What setsthis area apart
Government buildings in the Ministries Area near the Royal Diwan follow standard designs, and each building has its own water inspection point. Main valves are usually in a plant room on the lower ground floor or in an underground box. If the water will not shut at the first valve, we check the second point in the building, and you might have a meter and isolation valve on each floor. The top floor relies on pressure from a roof tank or pump, so its valve is not the same as the ground-level one.
The Ministries Area sits in Hawalli governorate, home to government offices, the royal court and massive administrative buildings.
Government buildings in the Ministries Area require an administrative permit before any work touches a water valve.
In short
The valve work.
Service
Water valve repair, replacement and fitting
Types
Main valves, branch valves, angle valves at fixtures
Where they sit
At the tank, on the roof, in the yard, under fixtures
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From above itto below it.
Changing a valve needs another valve above it, and that is the first thing we confirm.
We find the upstream shut off
We look for a valve able to stop the water before the failed one, and if there is none we shut off at the tank outlet or the supply point itself.
We drain before opening
The lowest tap on the run is opened so whatever is left in the pipework drains out, because unscrewing a valve on a full line soaks the area and makes the work harder.
We repair or replace
If the weep is only at the spindle and the body is sound, the packing is renewed. If the closing part is worn or the body is tired, a new valve goes in its place.
We open and close it twice
Pressure comes back and the valve is opened and closed several times with a tap watched after it, because a valve that works once does not necessarily close properly the next time.
Common questions
Questions about Valve repair in Ministries Area
The main valve sits in the first plant room near the main entrance, or at the first underground inspection chamber. We ask the security or maintenance staff where it is before we start work.
The weak pressure might be from a partly blocked valve on that floor or in the riser. We check every valve from ground level up to the top, and repair or replace the faulty one.
Other services
Other services in Ministries Area
Other work we do in the same area.