Toilet symptoms
Cistern and pansymptoms.
Four completely different cases, and each one sits on a different part.
01
A constant trickle inside
A running sound inside the cistern when nobody has flushed means the inlet valve is not closing fully, or the flush valve is passing into the pan. That water goes down the drain all day where you cannot see it.
02
The flush is weak
Needing to flush twice every time usually means the water level inside the cistern has dropped below where it should sit, or deposits are blocking the rim holes and killing the rush of water.
03
The pan rocks when used
Movement means the floor fixings have loosened or the floor under it is not flat. Constant rocking works the connection between the pan and the waste pipe loose, and the leak starts after that.
04
Water at the base
Wetness around the base has two possible sources: the seal between cistern and pan leaking from above, or the waste connection below the pan. Drying the area and watching where it returns tells them apart.
This area
What setsthis area apart
Salhiya is a dense commercial zone with office towers, flats, and shops, with many bathrooms close together. Communal tanks are small relative to use, and the valve and float face more pressure and cycles than a house. The valve may need repair every year or two instead of every four years. We fit strong, reliable parts for heavy use.
Salhiya sits in Kuwait governorate, a mixed commercial and residential zone with many offices, flats, and shops.
Commercial tanks in Salhiya fill and empty faster than residential tanks, so the valve opens and closes more times per day.
In short
The toilet work.
Service
Toilet pan and cistern repair
The parts
Inlet valve, float, flush valve, seal, pan connector
Types
Exposed cisterns, and concealed cisterns inside the wall
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the lid tothe last flush.
A cistern is read with the lid off, never guessed at from outside.
We lift the lid and read it
The water level inside tells us a lot: sitting low means the flush will be weak, sitting high enough to enter the overflow means the valve is not closing.
We split filling from flushing
We close the angle valve and watch the level. If it falls on its own, the flush valve is passing into the pan. If it holds, the fault is in the inlet valve.
We change the right part
An inlet valve, a float, a flush valve washer, or the large seal between cistern and pan. The part is replaced outright rather than adjusted.
We set it and flush it
The level is set to the mark, we flush it several times, and the base and the connections are checked dry before we leave.
Common questions
Questions about Toilet and cistern repair in Salhiya
The tank does not stop filling quickly, or water comes out weak, or slow drips appear under the tank. If you see any of these, the valve will fail very soon, especially in commercial spaces. Early checking and quick repair saves you trouble.
Yes, we cut off all units if there is one tank. If you are a shop or office, we shut water briefly to disassemble and clean the valve or fit a new one. Repair usually takes less than half an hour.
Other services
Other services in Salhiya
Other work we do in the same area.
Back to Toilet and cistern repair