Plumbing and sanitary
Ramadan Drain CleaningToilet and cistern repair in Dasma
Toilet and cistern repair in Dasma usually involves high water pressure on the mains and underslab tanks. Dasma is close to the city centre and its buildings are taller, and one bathroom may run from a rising main pressurised from below ground, so faults are not always straightforward.
Toilet symptoms
Cistern and pansymptoms.
Four completely different cases, and each one sits on a different part.
01
A constant trickle inside
A running sound inside the cistern when nobody has flushed means the inlet valve is not closing fully, or the flush valve is passing into the pan. That water goes down the drain all day where you cannot see it.
02
The flush is weak
Needing to flush twice every time usually means the water level inside the cistern has dropped below where it should sit, or deposits are blocking the rim holes and killing the rush of water.
03
The pan rocks when used
Movement means the floor fixings have loosened or the floor under it is not flat. Constant rocking works the connection between the pan and the waste pipe loose, and the leak starts after that.
04
Water at the base
Wetness around the base has two possible sources: the seal between cistern and pan leaking from above, or the waste connection below the pan. Drying the area and watching where it returns tells them apart.
This area
What setsthis area apart
Dasma has a mix of older and newer apartment blocks, and bathrooms in small flats are extremely tight with no room to move. The tank is either wall-mounted in a concealed cupboard or sunk below the slab in a basement room. If below ground, access is difficult and the area is damp, so we may need a jack or electric breakers to reach it. A pressurised tank valve works differently from a standard tank, and ordinary rods cannot clear it if it is trapped in a narrow pipe.
Dasma is a residential area in Kuwait governorate near the city centre, with apartment blocks of various heights and underslab cistern tanks.
Submerged tanks in Dasma sit at depths up to one and a half metres below the slab, requiring planned access.
In short
The toilet work.
Service
Toilet pan and cistern repair
The parts
Inlet valve, float, flush valve, seal, pan connector
Types
Exposed cisterns, and concealed cisterns inside the wall
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the lid tothe last flush.
A cistern is read with the lid off, never guessed at from outside.
We lift the lid and read it
The water level inside tells us a lot: sitting low means the flush will be weak, sitting high enough to enter the overflow means the valve is not closing.
We split filling from flushing
We close the angle valve and watch the level. If it falls on its own, the flush valve is passing into the pan. If it holds, the fault is in the inlet valve.
We change the right part
An inlet valve, a float, a flush valve washer, or the large seal between cistern and pan. The part is replaced outright rather than adjusted.
We set it and flush it
The level is set to the mark, we flush it several times, and the base and the connections are checked dry before we leave.
Common questions
Questions about Toilet and cistern repair in Dasma
We do not recommend you enter below ground yourself. We know how to access safely and move in confined spaces. We usually ask you not to go there because the air can be poor.
Yes, high pressure strains the valve and plastic float arms faster. We can install a pressure-rated valve if your line is indeed high. We check it and tell you if you need a stronger one.
Other services
Other services in Dasma
Other work we do in the same area.
Back to Toilet and cistern repair