Toilet symptoms
Cistern and pansymptoms.
Four completely different cases, and each one sits on a different part.
01
A constant trickle inside
A running sound inside the cistern when nobody has flushed means the inlet valve is not closing fully, or the flush valve is passing into the pan. That water goes down the drain all day where you cannot see it.
02
The flush is weak
Needing to flush twice every time usually means the water level inside the cistern has dropped below where it should sit, or deposits are blocking the rim holes and killing the rush of water.
03
The pan rocks when used
Movement means the floor fixings have loosened or the floor under it is not flat. Constant rocking works the connection between the pan and the waste pipe loose, and the leak starts after that.
04
Water at the base
Wetness around the base has two possible sources: the seal between cistern and pan leaking from above, or the waste connection below the pan. Drying the area and watching where it returns tells them apart.
This area
What setsthis area apart
Sharq has tall residential towers and luxury flats, with bathrooms on different floors, and supply lines running from the roof tank down through a long vertical stack. The valve and float must be simple and reliable, because fixing anything underground or in walls is difficult and time-consuming. We check the valve first and if we hear a drip, we need to disassemble the valve head and clean inside.
Sharq sits in Kuwait governorate, a modern area with tall residential towers and a commercial waterfront zone.
Tall Sharq buildings rely on one roof tank only, so maintaining its valve must be precise because any leak affects all units.
In short
The toilet work.
Service
Toilet pan and cistern repair
The parts
Inlet valve, float, flush valve, seal, pan connector
Types
Exposed cisterns, and concealed cisterns inside the wall
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the lid tothe last flush.
A cistern is read with the lid off, never guessed at from outside.
We lift the lid and read it
The water level inside tells us a lot: sitting low means the flush will be weak, sitting high enough to enter the overflow means the valve is not closing.
We split filling from flushing
We close the angle valve and watch the level. If it falls on its own, the flush valve is passing into the pan. If it holds, the fault is in the inlet valve.
We change the right part
An inlet valve, a float, a flush valve washer, or the large seal between cistern and pan. The part is replaced outright rather than adjusted.
We set it and flush it
The level is set to the mark, we flush it several times, and the base and the connections are checked dry before we leave.
Common questions
Questions about Toilet and cistern repair in Sharq
Most cases need only a new valve head, not the whole body. But if the valve body has rust or cracks, full replacement is necessary. We tell you which is cheaper and longer-lasting before we start work.
The noise usually comes from the valve itself if the float is stuck or the valve is old and vibrating. Some tanks have anti-vibration valves, but they need lime cleaning. We trace the sound and check the valve, float, and what needs fixing.
Nearby areas
More areas for Toilet and cistern repair
Same service, in nearby areas.
Other services
Other services in Sharq
Other work we do in the same area.
Back to Toilet and cistern repair