Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in South Surra
Sanitary fixture installation in South Surra means fitting toilets and sinks in the residential apartments and villas scattered across this mixed housing district. South Surra has multi-storey residential blocks and some single villas, with water and waste pipe layouts that vary depending on when the building was constructed.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Most apartments in South Surra sit on internal waste stacks rising from the basement, and water is distributed by a shared roof tank system. The few villas in the district have their own separate inspection chamber in the front yard. Installing a new tap or toilet in an apartment requires us to check whether the existing pipe can handle additional load, especially if you are adding two fixtures at the same time. Villas in South Surra sit close together, so waste may be shared between two houses.
South Surra is in Hawalli governorate, a mixed residential area with apartments and villas built in close proximity.
Waste stacks in South Surra apartment buildings are typically narrow and shared among several flats on the same landing.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in South Surra
If the existing pipe runs near the surface or behind cabinets, we can route the new tap easily. If we must drill, we use light tools and minimise damage to walls.
The roof tank may be too low or the pipe may have scale buildup. We check the system and tell you if you need the pipes flushed or a small booster pump installed.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in South Surra
Other work we do in the same area.
Back to Sanitary fixture installation