Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Sawaber
Sanitary fixture installation in Sawaber depends on building density and shared waste channels between units. Sawaber is a large residential tower complex downtown, with flats stacked densely and every unit connected to a central shared riser, so fitting any fixture needs coordination with existing drainage.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
The Sawaber complex is tall buildings downtown with small, tightly packed flats and bathrooms that follow a standard layout. Pipes run inside walls and floors, and each unit drains to one vertical stack in the outer wall of the tower. When you fit a new basin or toilet, we must check that the waste outlet does not cross electric cables or other runs. Water arrives from the rooftop pump room to each unit separately.
Sawaber is a residential complex in Kuwait governorate downtown, made up of tall towers where flats follow a uniform size and design.
Sewage stacks in Sawaber run inside the outer walls of the towers, shared between several units, so each floor has a hidden access point built into the wall.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Sawaber
Sawaber flats are tightly packed, so space is very tight. Water runs in one pipe from the hallway, and waste must exit to the shared stack in the wall. We need to open the wall panel or lift some tiles before we can see exactly where the existing runs go.
In the Sawaber towers, half the building or more drains to one stack. If your flat is on the fifth or sixth floor, the waste must exit to that same column. This means we must fit the basin or toilet at a specific angle so it drains correctly.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Sawaber
Other work we do in the same area.
Back to Sanitary fixture installation