Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Jaber Al-Ali
Sanitary fixture installation in Jaber Al-Ali starts with measuring the pipes and distances between tap points and floor level. Jaber Al-Ali is a suburban area in Ahmadi with a mix of older and newer villas, and the pipes can be hidden in walls or run openly depending on when the house was built.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Jaber Al-Ali villas range from older 1970s and 1980s style houses to modern villas with new designs. The older ones have thick galvanised steel or heavy copper pipe, and newer ones use lightweight plastic. If you need a new sink or shower installed, we check whether the existing pipes can handle modern pressure or need complete replacement. Bathroom floors in this area sit higher than street level, so the waste has to rise first before it drops to the main sewer.
Jaber Al-Ali sits in Ahmadi governorate, a mixed residential area of old and new villas near Jaber Al-Ali Co-op.
Some Jaber Al-Ali villas were built before plastic pipe became standard, so they have heavy metal pipes that need careful handling.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Jaber Al-Ali
If the pipes are too corroded and unsafe, we replace the section of pipe from the opening to the new fixture. We don't need to replace all pipes, just the part connected to the new fixture.
Most old villas in Jaber Al-Ali have roof tanks, so pressure is enough for a standard shower. If the shower is weak sometimes, the cause is usually a low tank or pipes clogged with rust.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Jaber Al-Ali
Other work we do in the same area.
Back to Sanitary fixture installation