Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Sabahiya
Sanitary fixture installation in Sabahiya starts by seeing the wall, the pipes, and the existing waste line before saying we fit something new. Sabahiya is a residential area in Ahmadi where most buildings are mid-age apartment blocks with scattered villas.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Sabahiya has few villas, mostly mid-rise apartment blocks from the 1960s and 70s with known waste runs because old plans were simple. Each flat has a main waste line running down the outer wall and dropping to ground, and extra drains tie in there. When fitting a new toilet or sink, the outlet height must match the existing line exactly. Old flats sometimes have no room for dual drainage, so a new fixture needs careful planning.
Sabahiya sits in Ahmadi governorate, a residential area made up mainly of mid-age apartment blocks with few villas.
Most Sabahiya flats date to the early phase of residential development, so their waste lines are fixed with no flexibility for major additions.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Sabahiya
We check if we can extend the existing line or run a second line from the main. Sometimes the floor needs a careful cut, but usually there is a solution without pulling everything apart.
If pipes are in place and close by, two or three days covers fitting and testing. If the line is far or needs running, a week might be needed until water and waste are connected properly.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Sabahiya
Other work we do in the same area.
Back to Sanitary fixture installation