Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Abraq Khitan
Sanitary fixture installation in Abraq Khitan requires knowledge of modern foundations and hidden lines in walls and floors. Abraq Khitan is a relatively new residential area with varied villas and flats, and its plumbing lines are more standardized and organized than older districts.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Abraq Khitan has standalone villas and apartment blocks built in the last two decades. Villas have varied foundations and some have raised surfaces or different levels, so drainage needs exact calculation of height and fall. The blocks here are modern with plasterboard walls and weak paint, so we need special preparation before fixing. Water and waste lines are drawn on the plans and may be hidden under marble or behind tile, so we use a detector before drilling. New flats and villas have a separate tank room, so pressure and flow are precisely regulated.
Abraq Khitan lies in Farwaniya governorate, a relatively modern residential area with diverse villas and apartment blocks.
Villas in Abraq Khitan usually connect to a shared street drainage line, and interior waste descends from upper floors to an inspection chamber.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Abraq Khitan
First we check the villa plan and measure the distance from the existing outlet and height from floor. We use a metal detector to locate pipes, and if the wall is plasterboard we fit a strong backing board under the tile before fixing.
If you drill without checking you might cut a water or drain pipe, and the repair becomes expensive. With a detector we know their exact location before we start the installation.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Abraq Khitan
Other work we do in the same area.
Back to Sanitary fixture installation