Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Dajeej
Sanitary fixture installation in Dajeej starts by understanding the building type and the existing lines. Dajeej is a fringe area in Farwaniya with mixed villas and flats, some old and some new, and waste lines vary by build year.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Villas in Dajeej have an inspection chamber near the house and the floor is usually at ground level, whereas flats in mixed buildings have higher lines that may run on brackets or rise from a stack. When we fit fixtures in a villa or a flat, we work with the existing pipework, basin position and toilet location. Different floor levels mean we sometimes need a carpenter or plumber to confirm the new fixture meets the old line at the right height.
Dajeej sits in Farwaniya governorate on the area's fringe, with a mix of old and new villas and flats.
Villas and flats in Dajeej have waste lines at different heights, and older buildings have less flexible pipework than new ones.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Dajeej
We check the existing line. If there's no old blockage or damage, the new fixture uses the same route but the fall has to be right and the pipes have to be sound.
We fit the fixture so water drains up to the higher line, which may mean using a drain pump or raising the basin and toilet position slightly, and ensuring the slope from fixture to line is correct.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Dajeej
Other work we do in the same area.
Back to Sanitary fixture installation