Plumbing and sanitary
Ramadan Drain CleaningMixer and faucet repair in Shuaiba Industrial
Mixer and faucet repair in Shuaiba Industrial starts with a quick check of the leak or the pressure drop. Shuaiba is an industrial zone with refineries and treatment plants, and buildings here run mixers built for heavy use, high-pressure water, and sometimes brackish supply.
Mixer symptoms
Four cases wesee often.
Each one of these points at a different part inside the mixer.
01
It drips after closing
If it keeps dripping with the handle fully closed, the ceramic discs inside the cartridge no longer meet cleanly. A single grain of grit is enough to score that face and keep the drip going.
02
The handle has gone stiff
A mixer that needs force to move has lost the grease inside it, or deposits have worked between the discs. Forcing it keeps breaking the cartridge, and you end up changing the mixer instead of a part.
03
The flow sprays sideways
When the flow breaks up and sprays to the sides, the small aerator at the tip is partly blocked. It is the easiest case of all, cleared by unscrewing the aerator and cleaning or replacing it.
04
Hot and cold are swapped
You open it towards cold and hot arrives, or the other way round. This follows a new installation with the two supplies reversed, or a cartridge refitted the wrong way up. The correction is simple and does not need a new mixer.
This area
What setsthis area apart
Shuaiba Industrial buildings hold administrative offices, workshops, and worker rest rooms, and the mixers here run all day under high pressure without a break. A leak does not stay at the spout; it runs down to the trap or the floor and wastes large amounts of water. We replace the cartridge, which is the soft heart of the mixer, and test the pressure at the tap itself before we leave, because Shuaiba's high pressure can break a new cartridge if we choose the wrong grade.
Shuaiba Industrial is in Ahmadi governorate, a large industrial zone that holds petrochemical plants and water and sewage treatment stations.
The water line in Shuaiba Industrial arrives at higher pressure than residential zones, so mixers wear faster and need cartridges rated for industrial pressure.
In short
The mixer work.
Service
Kitchen and bathroom mixer and tap repair
The parts
Ceramic cartridge, rubber rings, aerator, flexible tails
Types
Single lever, two handle, wall mounted, and hand shower
Where it applies
Kitchens and bathrooms in houses, flats and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the handleto the test.
Careful work on small parts, and all of it above the basin.
We close both angle valves
A mixer has two supplies, hot and cold, and both have to be closed. We then open the mixer to release the pressure still held in the two tails.
We lift the handle off
The handle is held by a small screw hidden under a plastic cap, and beneath it a ring clamps the cartridge. That comes off with the right tool so the mixer body is not scarred.
We change the cartridge
The old cartridge comes out and its seat is cleaned of deposits, because a new cartridge dropped onto a dirty seat gives you the same drip again before long.
We open it and check both
Both valves open, we run hot, cold and every position between, and we look under the basin while it runs to be sure the tails are not weeping.
Common questions
Questions about Mixer and faucet repair in Shuaiba Industrial
Yes, and the old cartridge cannot hold back water under high pressure. We swap it for a new one and the leak stops.
An industrial cartridge has a stronger internal seal that handles high pressure and warmer water, and lasts longer before wear sets in.
Nearby areas
More areas for Mixer and faucet repair
Same service, in nearby areas.
Other services
Other services in Shuaiba Industrial
Other work we do in the same area.
Back to Mixer and faucet repair