Plumbing and sanitary
Ramadan Drain CleaningKitchen flue installation in Mishref
Kitchen flue installation in Mishref starts by choosing the right duct route from the cooker hood so the pipe length does not kill the extraction power. Mishref has mixed flats and villas, and while most modern kitchens have extractor hoods, older ductwork fails to expel hot air to the outside properly.
Extraction symptoms
When the ductis the problem.
The hood runs loudly and the smell stays. That is where you start at the duct.
01
It runs and the smell stays
If the noise is strong but the air above the hob is not moving, the duct is either packed with grease, its outside termination is shut, or the hood was never ducted at all and is recirculating the air.
02
Steam gathering on the ceiling
Steam rising past the hood and collecting on the ceiling and the cupboards means the pull is weaker than the steam being produced. Usually the route is long, or it carries too many bends eating into the draw.
03
Grease dripping from the duct
Greasy drops coming off the joint above the hood mean grease has built up inside the duct, cooled and started to run back. That case needs the route cleaned, not just a new filter.
04
Outside air blows back in
Feeling hot air or dust coming in through the hood while it is off means the flap on the outside termination is broken or missing. That opening needs a flap that lifts with the extraction and falls shut after it.
This area
What setsthis area apart
Mishref mixes older buildings from the 1960s and 70s with newer blocks, and the villas have very high roof lines, so running the duct from the cooker to the outside means a long horizontal run with several bends. Flats in high-rise towers need either a horizontal run through the external wall or a vertical rise inside the partition wall up to the roof. We test air velocity after installation to confirm the flue does not choke the hood motor.
Mishref sits in Hawalli governorate, a mixed district of villas and flats near Kuwait University and Mishref Park.
Most older villas in Mishref were designed without separate kitchen flues, so installation often requires cutting a new hole in the external wall or breaking into the foundation line.
In short
The duct work.
Service
Kitchen flue and duct installation
Included
The duct route, joints, outside termination and its flap
Where it applies
Home and flat kitchens, and restaurant and shop kitchens
Harder cases
Flats with no outside wall, and long routes with bends
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we route it
From the hood tothe outside wall.
The route is decided before a single component is bought.
We find the nearest way out
We work out the shortest route from the hood to the nearest outside wall or light well, because every extra length and every bend takes from the pull.
We size the duct
The duct is sized against the hood and the route. Narrowing it so it can pass behind a cupboard kills the draw, however strong the hood is.
We run it and seal the joints
The duct runs with as few bends as possible, and every joint is sealed so no steam or smell escapes into a false ceiling or behind the cupboards.
We fit the flap and test
The outside opening takes a flap that lifts with the extraction and closes after it, then the hood runs and we confirm the air above the hob really is moving.
Common questions
Questions about Kitchen flue installation in Mishref
A narrow duct or one clogged with grease and dust kills extraction. We inspect the entire duct inside and fit a new one at the same or larger diameter if the run is long.
If the kitchen opens onto an external wall near a window, installation is straightforward. Otherwise we must cut the outer wall or route the duct through the window temporarily, which needs landlord approval.
Other services
Other services in Mishref
Other work we do in the same area.
Back to Kitchen flue installation