Plumbing and sanitary
Ramadan Drain CleaningKitchen flue installation in Salwa
Kitchen flue installation in Salwa means connecting a duct from the cooker hood to outside air without any obstruction to extraction. Salwa has residential flats and villas, and newer kitchens have powerful hoods but the ductwork often does not match their capacity.
Extraction symptoms
When the ductis the problem.
The hood runs loudly and the smell stays. That is where you start at the duct.
01
It runs and the smell stays
If the noise is strong but the air above the hob is not moving, the duct is either packed with grease, its outside termination is shut, or the hood was never ducted at all and is recirculating the air.
02
Steam gathering on the ceiling
Steam rising past the hood and collecting on the ceiling and the cupboards means the pull is weaker than the steam being produced. Usually the route is long, or it carries too many bends eating into the draw.
03
Grease dripping from the duct
Greasy drops coming off the joint above the hood mean grease has built up inside the duct, cooled and started to run back. That case needs the route cleaned, not just a new filter.
04
Outside air blows back in
Feeling hot air or dust coming in through the hood while it is off means the flap on the outside termination is broken or missing. That opening needs a flap that lifts with the extraction and falls shut after it.
This area
What setsthis area apart
Salwa near Mishref Park has relatively modern buildings, but the gaps between towers are tight, so routing ductwork across the ceiling requires planning to avoid interfering with ceiling-mounted air conditioning. Villas in Salwa are better planned, but many owners buy professional-grade hoods without upgrading the duct to match. The main restriction point is always the external outlet and how air distributes inside the pipe.
Salwa sits in Hawalli governorate, a modern residential area with villas and flats close to Mishref Park.
Kitchen ducts in Salwa flats run horizontally through the shared ceiling void between floors, not down vertical walls, because the building is laid out horizontally.
In short
The duct work.
Service
Kitchen flue and duct installation
Included
The duct route, joints, outside termination and its flap
Where it applies
Home and flat kitchens, and restaurant and shop kitchens
Harder cases
Flats with no outside wall, and long routes with bends
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we route it
From the hood tothe outside wall.
The route is decided before a single component is bought.
We find the nearest way out
We work out the shortest route from the hood to the nearest outside wall or light well, because every extra length and every bend takes from the pull.
We size the duct
The duct is sized against the hood and the route. Narrowing it so it can pass behind a cupboard kills the draw, however strong the hood is.
We run it and seal the joints
The duct runs with as few bends as possible, and every joint is sealed so no steam or smell escapes into a false ceiling or behind the cupboards.
We fit the flap and test
The outside opening takes a flap that lifts with the extraction and closes after it, then the hood runs and we confirm the air above the hob really is moving.
Common questions
Questions about Kitchen flue installation in Salwa
A hood runs but smoke takes long to leave or drifts back into the kitchen. We measure the duct diameter and length and calculate whether it needs widening or complete replacement.
Yes, but every extra metre costs extraction power. We fit a larger diameter pipe with minimal bends to keep suction strong, and we prefer not to exceed six metres of total run.
Other services
Other services in Salwa
Other work we do in the same area.
Back to Kitchen flue installation