Before it goes in
Four things tosettle first.
These are settled before the purchase, because changing them later means breaking.
01
An access panel for the pump
The pump and the circulation loops sit under the tub, and they need a panel to reach them from the side. A jacuzzi tiled in completely means any future repair starts by breaking that tiling.
02
A supply that fills it
A jacuzzi holds more than an ordinary bath, and filling it off a weak run takes so long that the first water cools before it is full. Pressure and pipe bore have to be checked before fitting.
03
A waste that empties it
A jacuzzi waste carries more, and it needs correct fall to the nearest point. A slow waste leaves water standing inside the circulation loops after emptying, and that produces odour over time.
04
A floor that carries it
A jacuzzi full of water with someone in it is heavy, and it needs a fully supported base rather than four feet on tiling. Level matters more here than on a bath, because the loops have to drain themselves.
This area
What setsthis area apart
Old Jahra houses near the souk and Red Fort are very old, with settled foundations, tilted floors and small bathrooms where the water pipes are usually rust inside. A jacuzzi is a heavy basin, and a sloping floor means the tub will not sit level without base work. Hot water in old houses usually comes from a small electric heater in the bathroom, so hot pressure is too weak to drive a jacuzzi pump naturally. You may need to upgrade the heater or add a small roof tank.
Old Jahra sits in Jahra governorate, a district of very old houses near the souk and Red Fort, with deteriorating foundations and unstable floors.
Old Jahra houses sit below street level and are prone to moisture, so jacuzzi drainage needs extra waterproofing under the floor.
In short
The jacuzzi work.
Service
Jacuzzi installation with water and waste connection
Included
Base support, supply, waste and trap, access panel
Electrical side
The pump's electrical connection is an electrician's work, not ours
Where it applies
Houses, flats and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From the base tothe first run.
An order that leaves the pump reachable at the end of it.
We check supply and waste
We measure the pressure arriving and the position and fall of the waste outlet, and compare both against what the tub needs before anything is set in place.
We build a supporting base
A base is prepared that supports the tub across its whole area and levels it, leaving enough room beneath for the pump and the loops.
We connect and leave the panel
Water and waste are connected and the loops arranged so they drain themselves, and the position of the access panel is set before any tiling goes around the tub.
We fill it and empty it
The tub is filled to its working level and every joint is checked, then it is emptied completely to confirm no water is left standing inside the loops.
Common questions
Questions about Jacuzzi installation in Jahra (Old)
First we inspect the foundation and floor beneath the bathroom. If there is cracking or settling, we do not recommend a jacuzzi. If the base is sound, there is no issue.
Small heaters in old homes cannot sustain a steady hot flow for a jacuzzi pump. You need a larger unit or an extra roof tank so pressure and temperature stay stable.
Nearby areas
More areas for Jacuzzi installation
Same service, in nearby areas.
Other services
Other services in Jahra (Old)
Other work we do in the same area.